Black & Decker FS1300CSL instruction manual Overview, Assembly / Adjustment SET-UP, Motor

642742-00 01 FS1300 FS1500CSL 11/29/07 2:18 PM Page 7

CAUTION: Use of controls or adjustments or performance of procedures other than those specified in this manual may result in hazardous laser radiation exposure.

The following laser warnings are located on your saw.

5DANGER

LASER RADIATION. AVOID DIRECT EYE EXPOSURE.

MAXIMUM OUTPUT POWER< 5mW@633nm- 670nm CLASS IIIa LASER PRODUCT. THIS

PRODUCT COMPLIES WITH THE APPLICABLE REQUIREMENTS OF 21CFR PARTS 1040.10 AND

1040.11.

Avoid exposure. Laser radiation is emitted from these apertures.

Evite la exposición. A través de estas aperturas se emite radiación láser.

information is printed on the nameplate. Lower voltage will cause loss of power and can result in over-heating. All Black

&Decker tools are factory-tested; if this tool does not operate, check the power supply. This tool is AC only.

OVERVIEW (FIG.6)

1.On/off switch

2.Laser on/off switch

3.Main handle

4.Secondary handle

5.Spindle lock button (FS1500CSL only)

6.Shoe

7.Saw blade

8.Saw blade guard

8a. Blade guard retracting lever

9.Laser

10.Saw blade wrench

11.Bevel adjustment knob

Rip fence not shown (FS1500CSL only)

6

1 2

The label on your tool may include the following symbols.

V..............volts mW..........milliwatts

3

5

nm				wavelength in nonometers
IIIa				Class IIIA Laser
A				amperes
Hz				hertz
W				watts
min				minutes
		............		alternating current
				direct current
			........
no				no load speed
		............		Class II Construction
…/min				revolutions or
	................			reciprocation per minute
				earthing terminal
		............
		............		safety alert symbol

MOTOR

Be sure your power supply agrees with nameplate marking. 120 Volts AC means your tool will operate on standard 60 Hz household power. Do not operate AC tools on DC. A rating of 120 volts AC/DC means that your tool will operate on standard 60 Hz AC or DC power. This

10	4
	9

8a11

6

8

7

ASSEMBLY / ADJUSTMENT

SET-UP

WARNING: Always unplug saw from power supply before any of the following operations.

ADJUSTING THE DEPTH OF CUT (FIG. 7 & 8)

The depth of cut should be set according to the thickness of the workpiece.

•Loosen the lever (12) to unlock the saw shoe.

7