Norton Abrasives C3130, C3120, C6120, C3126, C6136, C6130, C6126 Type Function, Starting the Engine

Item	Type	Function
12-volt Power Point	Control	Activates the 12-volt Power Point
Switch
Volt Meter	Gauge	Displays the charging status of the alternator
Tachometer	Gauge	Displays the Engine RPM
Oil Pressure	Gauge	Displays the Engine Oil Pressure in PSI

5.Starting the Engine:

A.Insure that the blade is installed properly

B.Insure that the blade is not touching any object or ground

C.Insure that all Guards are in places and are properly attached to the machine.

F.Insure that the work area is clear of any hazards

G.Use Approved:

Eye Protection	Hearing	Respiratory	Head Protection
	Protection	Protection

H.Connect Water supply to Garden Hose Water swivel located on the rear of the machine

I.Test Water system by opening and closing the water control value located on the same side as the blade. Water should run out of the water tubes located in the blade guard. See section: C. Water Supply on page 18 for more details.

J.Pull the Emergency Kill Switch up to insure that it is not active. If a problem occurs and it is required to stop or kill the engine press the Emergency Kill Switch.

K.Turn the Ignition Power Key Switch to the on position

L.Press the START button on the Engine Control Module to crank the engine. Release the START button when the engine begins to run.

17