11.Transmission Engage/Disengage lever by fully to the engage position and slowly push the Forward/Reverse Lever forward until the desired speed is reached. NOTE: The further the Forward/Reverse Lever is moved the faster the machine will move in that direction. If the engine begins to stall or the saw raises out of the cut slow the forward speed down!! The further the lever is pushed the fast the saw will move.
12.When the end of the cut is reached, raise the blade out of the cut by moving the Raise/Lower Switch to the rear of the machine until the blade is at least one (1) inch above the ground.
13.To use reverse, move the saw move the Speed Control lever to the rear of the saw. Only move the saw in reverse with the blade in the raise position. Always place the speed control back in the neutral position after moving the saw.
14.When moving the saw to a new location be sure that the blade is not touching the ground and always pay close attention to where you are moving and where the blade is at all times.
14.When the next cut is reached, align the saw with the cut and lower the blade into the concrete. Push the control lever forward until the lever aligns with the same location used to make the previous cut.
15.To disengage the transmission, place the Speed Control in the Neutral position and then slide the Transmission Engage/Disengage lever by fully to the “Disengage” position.
Caution: Do Not Engage Or Disengage The
Transmission While The Machine Is In The
Forward Or Reverse Positions!
22