I.PREPARATION
B.Assembly
Norton concrete saws are shipped partially assembled to protect parts of the saw which are subject to damage in transit. To prepare the saw for operation the following procedure is required.
1.Inspect the saw for shipping damage. If any damage is found, contact the shipper immediately and file a freight claim. The Norton Company is not responsible for any
2.Remove the saw from the pallet.
3.Place the one handle bars into each of the Handle Bar Retaining Hole located on the rear left and rear right hand sides of the console. NOTE: Never lift the saw by the Handle Bars.
4.Insure that the On/Off key is in the OFF position.
5.Remove the rear console cover and check the Battery for Electrolytes NOTE: Batteries are shipped with out Electrolytes.
Warning: The electrolyte is sulfuric acid. Read and observe all instructions and safety precautions on container. Wear safety goggles while handling and pouring the electrolyte. The electrolyte should be added to the battery in an area where running water is quickly available for rinsing, should it
come in contact with the body. Before disposing of the container, empty and rinse thoroughly with water.
6.Attach the Red Battery Cable to the Positive Battery Terminal and attach the Black Battery Cable to the Negative Battery Terminal.
7.Reattach the Rear Console Cover.
8.Make sure the hydraulic pump is filled with fluid (See section on hydraulic pumps).
9.Check the engine oil. The engine has been filled with oil and test run at the factory and should not require the addition of oil. Oil capacity of crankcase is 6.4 U.S. quarts (6.1 liters).
10.Fill the fuel tank with Diesel fuel. NOTE: Units are shipped with out fuel.
11.Attach the Muffler and Muffler Retaining Clamp.
Read and understand the remaining sections of this Owners Manual. NOTE: Do not install the blade until it is time to use the saw. ANSI regulations prohibit the transportation of any concrete saw with the blade installed.
7