Graco H40 Actual Temperature Key/LED, Target Temperature Key/LED, Temperature Scale Keys/LEDs

Page 19

Temperature Controls and Indicators

Actual Temperature Key/LED

Press to display actual temperature.

Press and hold to display electrical cur- rent.

Target Temperature Key/LED

Press to display target temperature.

Press and hold to display heater control circuit board temperature.

Temperature Scale

Keys/LEDs

Press °F or °C to change temperature

scale.

Heater Zone On/Off

Keys/LEDs

Press to turn heater zones on and off.

Also clears heater zone diagnostic codes, see page 42.

LEDs flash when heater zones are on. The duration of each flash shows the extent that the heater is turned on.

Temperature Arrow Keys

Press , then press or to

adjust temperature settings in 1 degree incre- ments.

Temperature Displays

Show actual temperature or target tempera- ture of heater zones, depending on selected mode. Defaults to actual at startup. Range is 32-190°F (0-88°C) for A and B, 32-180°F (0-82°C) for hose.

312062W

19

Image 19

Contents Operation Important Safety InstructionsContents Systems GCP2R2 Series ModelsApprovals XP2 SeriesPart Description Reactor Electrical DiagramsSupplied Manuals Reactor Hydraulic Proportioner Part DescriptionRelated Manuals Electric Shock Hazard Skin Injection Hazard Pressurized Aluminum Parts Hazard Keep Components a and B Separate Important Two-Component Material InformationIsocyanate Conditions Material Self-ignitionChanging Materials Foam Resins with 245 fa Blowing AgentsSide Supply Detail M Typical Installation, with circulationKey for FIG Side Supply DetailTypical Installation, without circulation Typical Installation, without circulationComponent Identification Detail of Serial No Plate inside cabinet Detail of Reactor Fluid Manifold shroud removed for clarityMain Power Switch Temperature Controls and IndicatorsRed Stop Button Temperature Arrow Keys Actual Temperature Key/LEDTarget Temperature Key/LED Temperature Scale Keys/LEDsSize Component Circuit BreakersPressure Key/LED Motor Controls and IndicatorsMotor ON/OFF Key/LED PSI/BAR Keys/LEDs Park Key/LEDMotor Control Arrow Keys Spray AdjustmentsCycle Count Key/LED Hydraulic Pressure Control KnobLocate Reactor SetupGeneral equipment guidelines Full Load Voltage Peak System Part Phase Amps WattsElectrical Requirements KW/Full Load Amps Electrical RequirementsPart Model AWG mm Power Cord RequirementsCord Specification Connect electrical cordConnect feed pumps Connect pressure relief lines Install Fluid Temperature Sensor FTSPressure check hose Connect heated hoseClose gun fluid manifold valves a and B Connect whip hose to gun fluid mani- foldGround system Lubrication system setupCheck hydraulic fluid level Check generator fuel level StartupSet temperatures Manual current control mode only Set pressure Change pressure imbalance setting optionalPSI BAR Available Pressure Imbalance SettingsSpraying Open gun fluid manifold valves a and B Standby Shutdown Pressure Relief Procedure Lation Fluid CirculationCirculation Through Gun Manifold Code Code Name Alarm Zone Diagnostic CodesCode Code Name Alarm or Motor Control Diagnostic CodesFrequency of Oil Changes Ambient Recommended Temperature MaintenanceFluid Inlet Strainer Fluid Inlet Strainer ScreenPump Lubrication System Pump Lubrication SystemFlushing Dimension In. mm DimensionsTop View Category Data Technical DataFoam Performance Chart Performance ChartsCoatings Performance Chart Flow Rate in gpm lpm 110Graco Information Graco Standard Warranty