Graco H50 Motor Controls and Indicators, Motor ON/OFF Key/LED PSI/BAR Keys/LEDs, Park Key/LED

Page 21

Motor Controls and Indicators

Motor Controls and Indicators

NOTICE

To prevent damage to the softkey buttons, do not press the buttons with sharp objects such as pens, plastic cards, or fingernails.

Arrow Keys

Motor ON/OFF Key

Pressure/Cycle Display

ON / OFF

PARK Key

Pressure Key

Cycle Count Key

PARK

PSI/BAR Keys

PSI

BAR

FIG. 5. Motor Controls and Indicators

Motor ON/OFF Key/LED

PSI/BAR Keys/LEDs

Press to turn motor ON and OFF. Also

clears some motor control diagnostic codes, see page 43.

PARK Key/LED

Press at end of day to cycle component

A pump to home position, submerging dis- placement rod. Trigger gun until pump stops. Once parked, motor will automatically shut off.

Press PSI or BAR to change pressure scale.

Pressure Key/LED

Press to display fluid pressure.

If pressures are imbalanced, display shows higher of two pressures.

312062W

21

Image 21
Contents Operation Important Safety InstructionsContents Systems GCP2R2 Series ModelsApprovals XP2 SeriesSupplied Manuals Reactor Electrical DiagramsReactor Hydraulic Proportioner Part Description Part DescriptionRelated Manuals Electric Shock Hazard Skin Injection Hazard Pressurized Aluminum Parts Hazard Isocyanate Conditions Important Two-Component Material InformationMaterial Self-ignition Keep Components a and B SeparateChanging Materials Foam Resins with 245 fa Blowing AgentsKey for FIG Typical Installation, with circulationSide Supply Detail Side Supply Detail MTypical Installation, without circulation Typical Installation, without circulationComponent Identification Detail of Serial No Plate inside cabinet Detail of Reactor Fluid Manifold shroud removed for clarityTemperature Controls and Indicators Main Power SwitchRed Stop Button Target Temperature Key/LED Actual Temperature Key/LEDTemperature Scale Keys/LEDs Temperature Arrow KeysSize Component Circuit BreakersMotor ON/OFF Key/LED PSI/BAR Keys/LEDs Motor Controls and IndicatorsPark Key/LED Pressure Key/LEDCycle Count Key/LED Spray AdjustmentsHydraulic Pressure Control Knob Motor Control Arrow KeysSetup Locate ReactorGeneral equipment guidelines Electrical Requirements KW/Full Load Amps Phase Amps WattsElectrical Requirements Full Load Voltage Peak System PartCord Specification Power Cord RequirementsConnect electrical cord Part Model AWG mmConnect feed pumps Connect pressure relief lines Install Fluid Temperature Sensor FTSClose gun fluid manifold valves a and B Connect heated hoseConnect whip hose to gun fluid mani- fold Pressure check hoseLubrication system setup Ground systemCheck hydraulic fluid level Check generator fuel level StartupSet temperatures Manual current control mode only Set pressure Change pressure imbalance setting optionalPSI BAR Available Pressure Imbalance SettingsSpraying Open gun fluid manifold valves a and B Standby Shutdown Pressure Relief Procedure Lation Fluid CirculationCirculation Through Gun Manifold Code Code Name Alarm Zone Diagnostic CodesCode Code Name Alarm or Motor Control Diagnostic CodesFrequency of Oil Changes Ambient Recommended Temperature MaintenanceFluid Inlet Strainer Fluid Inlet Strainer ScreenPump Lubrication System Pump Lubrication SystemFlushing Dimensions Dimension In. mmTop View Category Data Technical DataPerformance Charts Foam Performance ChartCoatings Performance Chart Flow Rate in gpm lpm 110Graco Information Graco Standard Warranty