Graco H40, H50, H25 important safety instructions Set temperatures

Page 31

Startup

Do not mix components A and B during startup. Always provide two grounded waste containers to keep component A and compo- nent B fluids separate.

h.Use feed pumps to load system. Hold gun fluid manifold over two grounded waste containers. Open fluid valves A and B until clean, air-free fluid comes from valves. Close valves.

ti2484a

8. Set temperatures

A

B

°F

°C

Temperature Controls and Indicators, see page 18

This equipment is used with heated fluid, which can cause equipment surfaces to become very hot. To avoid severe burns:

•Do not touch hot fluid or equipment.

•Allow equipment to cool completely before touching it.

•Wear gloves if fluid temperature exceeds 110°F (43°C).

a. Turn main power ON

.

b. Press °F or °C to change tem-

perature scale.

c.Press to display target tempera- tures.

d. To set A heat zone target tempera-

ture, press or until display

shows desired temperature. Repeat for

Band zones.

For zone only, if FTS is discon-

nected at startup, display will show hose current (0A). See step j, page 32.

312062W

31

Image 31

Contents Operation Important Safety InstructionsContents Systems GCP2R2 Series ModelsApprovals XP2 SeriesPart Description Reactor Electrical DiagramsSupplied Manuals Reactor Hydraulic Proportioner Part DescriptionRelated Manuals Electric Shock Hazard Skin Injection Hazard Pressurized Aluminum Parts Hazard Keep Components a and B Separate Important Two-Component Material InformationIsocyanate Conditions Material Self-ignitionChanging Materials Foam Resins with 245 fa Blowing AgentsSide Supply Detail M Typical Installation, with circulationKey for FIG Side Supply DetailTypical Installation, without circulation Typical Installation, without circulationComponent Identification Detail of Serial No Plate inside cabinet Detail of Reactor Fluid Manifold shroud removed for clarityMain Power Switch Temperature Controls and IndicatorsRed Stop Button Temperature Arrow Keys Actual Temperature Key/LEDTarget Temperature Key/LED Temperature Scale Keys/LEDsSize Component Circuit BreakersPressure Key/LED Motor Controls and IndicatorsMotor ON/OFF Key/LED PSI/BAR Keys/LEDs Park Key/LEDMotor Control Arrow Keys Spray AdjustmentsCycle Count Key/LED Hydraulic Pressure Control KnobLocate Reactor SetupGeneral equipment guidelines Full Load Voltage Peak System Part Phase Amps WattsElectrical Requirements KW/Full Load Amps Electrical RequirementsPart Model AWG mm Power Cord RequirementsCord Specification Connect electrical cordConnect feed pumps Connect pressure relief lines Install Fluid Temperature Sensor FTSPressure check hose Connect heated hoseClose gun fluid manifold valves a and B Connect whip hose to gun fluid mani- foldGround system Lubrication system setupCheck hydraulic fluid level Check generator fuel level StartupSet temperatures Manual current control mode only Set pressure Change pressure imbalance setting optionalPSI BAR Available Pressure Imbalance SettingsSpraying Open gun fluid manifold valves a and B Standby Shutdown Pressure Relief Procedure Lation Fluid CirculationCirculation Through Gun Manifold Code Code Name Alarm Zone Diagnostic CodesCode Code Name Alarm or Motor Control Diagnostic CodesFrequency of Oil Changes Ambient Recommended Temperature MaintenanceFluid Inlet Strainer Fluid Inlet Strainer ScreenPump Lubrication System Pump Lubrication SystemFlushing Dimension In. mm DimensionsTop View Category Data Technical DataFoam Performance Chart Performance ChartsCoatings Performance Chart Flow Rate in gpm lpm 110Graco Information Graco Standard Warranty