TROUBLESHOOTING GUIDE
| PROBLEM | CAUSE |
| CORRECTION |
|
|
|
|
|
| |
Air leak from safety valve. | Possible defect in safety valve. | Operate safety valve manually by pulling on ring. If |
| ||
|
|
| valve still leaks, it should be replaced. |
| |
|
|
|
|
| |
| Knocking Noise | Defective check valve. | Remove and clean, or replace. |
| |
|
|
|
|
| |
| Compressor is not supplying | Prolonged excessive use of air. | Decrease amount of air usage. |
| |
| enough air to operate accesso- | Compressor is not large enough for air | Check the accessory air requirement. If it is higher than |
| |
| ries. |
| |||
|
| requirement. | the SCFM or pressure supplied by your air compres- |
| |
|
|
| sor, you need a larger compressor. |
| |
|
| Hole in hose. | Check and replace if required. |
| |
|
| Check valve restricted. | Remove and clean, or replace. |
| |
|
| Air leaks. | Tighten fittings. (See Air Leaks Section of |
| |
|
|
| Troubleshooting Guide.) |
| |
|
|
|
|
| |
| Motor will not run. | Tank pressure exceeds pressure switch | Motor will start automatically when tank pressure |
| |
|
| drops below |
| ||
|
| Wrong gauge wire or length of exten- | Check for proper gauge wire and cord length. |
| |
|
| sion cord. |
|
|
|
|
| Check valve stuck open. | Remove and clean, or replace. |
| |
|
| Loose electrical connections. | Check wiring connection inside pressure switch and |
| |
|
|
| terminal box area. |
| |
|
| Paint spray on internal motor parts. | Have checked at an Authorized Warranty Service |
| |
|
|
| Center. Do not operate the compressor in the paint |
| |
|
|
| spray area. See flammable vapor warning. |
| |
|
| Possible defective motor. | Have checked at an Authorized Warranty Service |
| |
|
|
| Center. |
| |
|
| Fuse blown, circuit breaker tripped. | 1. Check fuse box for blown fuse and replace, if |
| |
|
|
|
| necessary. Reset circuit breaker. Do not use a |
|
|
|
|
| fuse or circuit breaker with higher rating than that |
|
|
|
|
| specified for your particular branch circuit. |
|
|
|
| 2. Check for proper fuse. You should be using a |
| |
|
|
|
| time delay fuse. |
|
|
|
| 3. | Check for low voltage conditions and/or proper |
|
|
|
|
| extension cord. |
|
|
|
| 4. | Disconnect the other electrical appliances from |
|
|
|
|
| circuit or operate the compressor in its own |
|
|
|
|
| branch circuit. |
|
|
| Pressure release valve on pressure | Bleed the line by pushing the lever on the pressure |
| |
|
| switch has not unloaded head pres- | switch to the “off” position; if the valve does not open, |
| |
|
| sure. | replace it. |
| |
|
|
|
|
| |
| Regulator knob continuous air | Dirty or damaged regulator internal | Replace regulator. |
| |
| leak. Regulator will not shut off | parts. |
|
|
|
| at air outlet. |
|
|
|
|
|
|
|
|
|
|
D23708 | |
|