Porter-Cable PC1800DS Important Safety Instruction for Battery Packs, Read ALL Instructions

Page 6

90550099 PC1800DS Crdl Sander REVISED 4/1/09 1:52 PM Page 6

supply, the charger can be shorted by foreign material. Foreign materials of a conductive nature such as, but not limited to, steel wool, aluminum foil, or any buildup of metallic particles should be kept away from charger cavities. Always unplug the charger from the power supply when there is no battery pack in the cavity. Unplug charger before attempting to clean.

•DO NOT attempt to charge the battery pack with any chargers other than the ones in this manual. The charger and battery pack are specifically designed to work together.

•These chargers are not intended for any uses other than charging designated PORTER-CABLErechargeable batteries. Any other uses may result in risk of fire, electric shock or electrocution.

•Do not expose charger to rain or snow.

•Pull by plug rather than cord when disconnecting charger. This will reduce risk of damage to electric plug and cord.

•Make sure that cord is located so that it will not be stepped on, tripped over, or otherwise subjected to damage or stress.

•Do not use an extension cord unless it is absolutely necessary. Use of improper extension cord could result in risk of fire, electric shock, or electrocution.

•An extension cord must have adequate wire size (AWG or American Wire Gauge) for safety. The smaller the gauge number of the wire, the greater the capacity of the cable, that is 16 gauge has more capacity than 18 gauge. When using more than one extension to make up the total length, be sure each individual extension contains at least the minimum wire size.

•Do not place any object on top of charger or place the charger on a soft surface that might block the ventilation slots and result in excessive internal heat. Place the charger in a position away from any heat source. The charger is ventilated through slots in the top and the bottom of the housing.

•Do not mount charger on wall or permanently affix charger to any surface. The charger is intended to use on a flat, stable surface (i.e., table top, bench top).

•Do not operate charger with damaged cord or plug — have them replaced immediately.

•Do not operate charger if it has received a sharp blow, been dropped, or otherwise damaged in any way. Take it to an authorized service center.

•Do not disassemble charger; take it to an authorized service center when service or repair is required. Incorrect reassembly may result in a risk of electric shock, electrocution or fire.

•Disconnect the charger from the outlet before attempting any cleaning. This will reduce the risk of electric shock. Removing the battery pack will not reduce this risk.

•NEVER attempt to connect 2 chargers together.

•The charger is designed to operate on standard household electrical power (120 Volts). Do not attempt to use it on any other voltage.

SAVE THESE INSTRUCTIONS

IMPORTANT SAFETY INSTRUCTION FOR BATTERY PACKS

: For safe operation, read this manual and manuals originally supplied with tool before using the charger.

The battery pack is not fully charged out of the carton. Before using the battery pack and charger, read the safety instructions below. Then follow charging procedures outlined.

READ ALL INSTRUCTIONS

•Do not incinerate the battery pack even if it is severely damaged or is completely worn out. The battery pack can explode in a fire. Toxic fumes and materials are created when LI-ION battery packs are burned.

•Do not charge or use battery in explosive atmospheres, such as in the presence of flammable liquids, gases or dust. Inserting or removing the battery from the charger may ignite the dust or fumes.

•If battery contents come into contact with the skin, immediately wash area with mild soap and water. If battery liquid gets into the eye, rinse water over the open eye

6

Page 5 Page 7
Image 6
Page 5 Page 7
Contents Advertencia Léase Este Catalog NumberGeneral Power Tool Safety Warnings Specific Safety Rules Safety Guidelines Definitions Symbols Important Safety Instructions for Battery ChargersFunctional Description Important Safety Instruction for Battery Packs Read ALL InstructionsBattery CAP Information Charging ProcedureStorage Recommendations HOT/COLD Pack Delay Charger DiagnosticsBAD Battery Problem Power LineCleaning and disposal Personal safetyEnvironmental safety Lead based paintOperation Figure E SwitchOperating Instructions Detail SandingDust Collection / Vacuum Port Adaptor figure Tip of the Sanding Base figure GFinger Attachment figure H Hints for optimum useReplacement Parts Service and Repairs TroubleshootingMaintenance Rbrc SealThree Year Limited Warranty AccessoriesDE Catalogue 90550099 PC1800DS Crdl Sander Revised 4/1/09 152 PM 90550099 PC1800DS Crdl Sander Revised 4/1/09 152 PM Consignes DE Sécurité Particulières Lignes Directrices EN Matière DE Sécurité DéfinitionsSymboles Conserver CES DirectivesDescription Fonctionnelle Lire Toutes LES Directives Information Concernant LE Capuchon DU BLOC-PILE Recommandations EN Matière DE RangementFonctions DE Diagnostic DU Chargeur Procédure DE ChargeBLOC-PILES Laissé Dans LE Chargeur Fonction DE Suspension DU BLOC-PILES CHAUD/FROIDProblème Avec LE Secteur Remarques Importantes Pour LE ChargementProtection de l’environnement Ponçage Peintue à base de plombSécurité personnelle Nettoyage et déchetsFonctionnement Fig. E FonctionnementInterrupteur Fixation du papier abrasif Fig. FAdaptateur d’orifice de dépoussiérage/d’aspiration Fig Accessoire doigt de ponçage Fig. HPointe de la base abrasive Fig. G Conseils pour optimiser l’utilisationLE Sceau Srprcmc DépannagePièces DE Rechange Entretien ET Réparation AccessoiresEntretien Garantie Limitée DE Trois ANSRemplacement DES Étiquettes D’AVERTISSEMENT Catálogo N 90550099 PC1800DS Crdl Sander Revised 4/1/09 152 PM 90550099 PC1800DS Crdl Sander Revised 4/1/09 152 PM Normas Específicas DE Seguridad Pautas DE SEGURIDAD/DEFINICIONESConserve Estas Instrucciones SímbolosDescripción DE LAS Funciones LEA Todas LAS Instrucciones Procedimiento DE Carga Información Acerca DEL Protector DE LA BateríaRecomendaciones CON Respecto AL Almacenamiento Diagnóstico DEL CargadorDejar LA Batería EN EL Cargador Línea DE Potencia CON ProblemasRetraso POR Paquete CALIENTE/FRÍO Notas Importantes Sobre LA CargaSeguridad ambiental Lijado Lijado de pinturas con base de plomoSeguridad personal Limpieza y desechoInstrucciones DE Operación InterruptorOperacion Fig. E Punta de la base para lijar fig. G Lijado de detalleMontaje del papel de lija Fig. F Dispositivo para detalles finos Fig. HAdaptador para el colector de la aspiradora figura Consejos para un uso óptimoDetección DE Problemas MantenimientoPiezas DE Repuesto Garantía Limitada DE Tres Años Mantenimiento Y ReparacionesAccesorios Reemplazo DE LAS Etiquetas DE AdvertenciaEspecificaciones
Top Page Image Contents