Chapter 2
Setup and Configuration
StudioPix™ fixture setup includes mounting, connecting to power and DMX linking and configuration.
Use the following steps to set up and configure your StudioPix™ fixture:
1.Unpack the fixture.
2.Install power cord cap for your location.
3.Mount the fixture upright or suspended from a standard truss.
4.Connect the fixture to a DMX controller via DMX cabling.
5.Connect the fixture to power.
6.Configure the fixture for DMX control.
Unpacking the Fixture
The StudioPix™ fixture is transported in a shipping box or road case specifically designed to protect the product during transport. When unpacking, inspect the fixture for physical damage to components. High End Systems® assumes no responsibility for products that are damaged during transport. Return a product for repair in its shipping box or road case. Before sending anything to the factory, call your High End Systems dealer/distributor for a Return Material Authorization (RMA) number. The factory cannot accept any goods shipped without an RMA number.
Installing a Power Cord Cap
The StudioPix™ fixture’s custom power cord ships without a power cord cap. Use the information in this section to install the correct power cord cap for your location.
Because of the variety of power cord caps used worldwide, High End Systems, Inc. cannot make specific recommendations for the power cord cap. Contact a local authority for the type of power cord cap needed. When installing the power cord cap, note that the cores in the mains lead are colored according to the following code:
•green and yellow = earth
•blue = neutral
•brown = live
StudioPix™ Pixelation Luminaire User Manual | 7 |