CHAPTER 2
Setup and Configuration
Truss Mounting
If you are mounting the fixture(s) on a truss or another type of support, verify that the truss or support will handle the weight of all the devices you are mounting.
Safety Cable
High End Systems strongly recommends that you use a safety cable when mounting any fixture. You must supply your own safety cable and verify that the cable is capable of supporting the weight of the fixture. You can order galvanized safety cables from your High End Systems dealer/distributor (see Related Products and Accessories on page 3).
Clamp
You must supply your own clamps and verify the clamp is capable of supporting the weight of the fixture. You can order deluxe
Mounting Procedure
To mount StudioPix fixtures on a truss:
1.Disconnect power to the fixture. If the fixture has been operating, allow the fixture to cool before handling.
2.Always stand on a firm, stable surface when mounting a fixture to its support. The fixture should be at a height where you can comfortably work on it, and should either be resting on a stable surface, or held securely.
3.Attach suitable clamps through the center holes on the base of the fixture. Install two locking washers per clamp when attaching the clamps to the fixture’s base.
4.Tighten the clamps firmly to the fixture’s base and to the support.
5.Loop one or more suitable safety cables around the support, through the side holes in the fixture’s base, and around the fixture’s handles.
truss
clamp
safety
cable 
locking washers
Holes for | Holes for |
attaching | securing |
clamps | safety cables |
StudioPix™ Pixelation Luminaire User Manual | 9 |