Maintenance Instructions
All repairs and maintenance recommended in this instruc- tion manual must be per- formed by a qualified repair technician who is experienced with the repair of electric tools, a qualified service organiza- tion, or Master Appliance Corp.’s Repair Department.
A Master Heat Gun Main- tenance and Repair Manual is available upon request. Send your request to:
Master Appliance Corp.
Attn: Repair Department
2420 - 18th Street
Racine, Wl 53403
For prompt and efficient main- tenance and repair service, return your product to:
Master Appliance Corp.
Attn: Repair Department
2420 - 18th Street
Racine, Wl 53403
Please enclose a note describing your problem and your phone number.
WARNING: Always unplug your tool before performing any maintenance or repairs. Use only identical Master Appliance brand replacement parts.
Motor Brushes
1)Unplug tool before remov- ing brushes.
2)Inspect brushes regularly (at least every 100 hours of running time). If brushes are less than 1/8" long, replace them immediately.
3)Remove brushes one at a time. To remove, unscrew the brush cap located on the side of the housing, tip the hole downward and let the brush and spring fall out.
4)Always replace brushes in sets (2 brushes and 2 springs) to insure equal ten- sion. If returning partially used brushes, match the curvature of the brushes to the commutator.
5)To replace, drop new brush in hole, drop in new spring and screw on brush cap.
6)After second set of brushes are worn down, return the tool to a qualified repair technician who is familiar with the repair of electric tools, a qualified service organization or Master Appliance Corp.'s Repair Department for interior cleaning, dressing of the commutator, or whatever maintenance is required.
7)Always use original Master Appliance Corp. replace- ment parts.
Lubrication
The bearings are lubricated at the factory and require no fur- ther lubrication.
Cleaning
Unplug heat gun before clean- ing. To clean outside of tool, use only a mild soap and damp cloth. Do not use other cleaning agents, turpentine, gasoline, lacquer or paint thin- ner, or other solvents that may contain chemicals which are harmful to plastics and other insulating materials. Never immerse tool in a liquid or allow a liquid to enter inside the tool. Make sure all vents and openings are free and clear of debris.
9