English
ASSEMBLY AND OPERATION
APPLICATIONS
◯Finish polishing of woodwork surfaces.
◯Sanding surfaces of woodwork or sheet metal prior to painting, etc.
PRIOR TO OPERATION
1.Power source
Ensure that the power source to be utilized conforms to the power source requirements specified on the product nameplate.
2.Power switch
Ensure that the switch is in the OFF position. If the plug is connected to a receptacle while the switch is in the ON position, the power tool will start operating immediately and can cause serious injury.
3.Extension cord
When the work area is far away from the power source, use an extension cord of sufficient thickness and rated capacity. The extension cord should be kept as short as practicable.
WARNING:
Damaged cord must be replaced or repaired.
4.Check the receptacle
If the receptacle only loosely accepts the plug, the receptacle must be repaired. Contact a licensed electrician to make appropriate repairs.
If such a fautly receptacle is used, it may cause overheating, resulting in a serious hazard.
5.Check your working environment
Ensure the following before operation;
◯No flammable gas, liquid, or object at worksite.
◯Sanding thin steel sheet may cause a high booming sound. In this case, place a rubber mat under the workpiece.
◯Take appropriate noise preventive measures to prevent adverse affects on the environment by electrical noise.
◯Clear the area of children or unauthorized personnel.
10