ASSEMBLY
To reduce the risk of injury, turn unit off and disconnect it from power source before installing and removing accessories, before adjusting or when making repairs. An accidental
ASSEMBLY TOOLS REQUIRED
1/2"
ASSEMBLY TIME ESTIMATE
Assembly for this machine takes approximately
HOW TO ASSEMBLE THE STAND
1.Select one of the side pieces (A) Fig. 1A and attach one of the feet (B) to it with the short end of the foot to the front of the machine, using two
2.Attach the back brace (D) to the two side pieces with
3.Attach the center piece (E) to the rest of the assembly with
A
B
C
Fig. 1A
D
Fig. 1B
E
Fig. 1C
HOW TO ATTACH THE SANDER TO THE STAND
This machine is heavy. Use two or more people when lifting.
1.Place the machine on its end (Fig. 2), resting on the two wood blocks (not supplied). Attach the stand.
2.Position the front of the stand (large black panel (E) Fig. 1C) on the front of the machine (power switch side). Match the holes in the stand with those in the machine. Insert the
HOW TO ATTACH THE LEVELING FEET TO THE STAND
1.The jam nut should already be on the leveling foot. If not, place the jam nut (A) Fig. 2A on the leveling foot
(B).
2.Screw the leveling foot with the jam nut into the hole provided on the leg.
3.CAREFULLY lift the machine upright.
4.Level the machine by turning the leveling feet (B) one way or the other. When the machine is level, tighten the jam nuts (A).
5.Insert the end caps into the ends of the legs.
Fig. 2
A
B
7