INSTALLING THE DISC SANDER TABLE
1.Thread an M8 x 1.25 x 20mm hex socket head screw (A) Fig. 10 partially into the hole in the base of the sander. Insert the rod (B) into the hole. Align the flat of the rod (B) with the screw (A). Tighten the screw (A).
2.Slide the table assembly (C) Fig. 11 on the rod (B).
3.Thread an M8 x 1.25 x 20mm hex socket head screw (A) Fig. 11 into the hole in the table support bracket. Align the flat on the rod (B) with the screw (A). Tighten the screw (A).
A
Fig. 10
B
Fig. 11
F 
E
C
B
A
WARNING: To avoid trapping the work or fingers between the table and the sanding disc, the table edge (E) Fig. 11 should be positioned a maximum of 1/16 in. away from the sanding disc (F). Loosen the screw (A) and adjust the table accordingly.
ATTACHING THE DUST CHUTE
Align the three holes in the dust chute (A) Fig. 12 with the three holes in the left side of the sanding base. Insert the pan head screw (B) Fig.12 through the hole in the dust spout and thread it into the taped hole in the sander base. Repeat this process for the two remaining holes.
B 
A
Fig. 12
INSTALLING THE BACKSTOP ON THE SANDING ARM
Install the backstop (A) Fig. 13 on the sanding arm using the
WARNING: To avoid trapping the work or fingers between the backstop and the sanding belt, the edge of the backstop (D) Fig. 13 should be positioned a maximum of 1/16 in. away from the sanding belt (E).
D
Fig. 13
C | B |
A
E
10