Schumacher SI-82-6 owner manual Completion of Charge Automatic Charge Only

Page 46

Completion of Charge (Automatic Charge Only)

When the FULL CHARGE (green) LED is lit, the charger has stopped charging and switched to the Maintain Mode of operation. If the 12V DEEP CYCLE battery type was selected, the CHARGED (green) LED comes on when the battery is charged enough for normal use.

Maintain Mode (Automatic Charge Only)

When the FULL CHARGE (green) LED is lit, the charger has started Maintain Mode. In this mode, the charger keeps the battery fully charged by delivering a small current when necessary. If the battery voltage drops below a preset level, the charger will go back into charge mode until the battery voltage returns to the full charge level, at which point the charger will return to maintain mode. The voltage is maintained at a level determined by the battery type selected.

NOTE: An automatic charge automatically switches between charge mode and maintain mode as necessary. The FULL CHARGE (green) LED will cycle on when the battery is at full charge and off when the voltage drops below a preset level and the charger goes into charge mode. This cycle will continue, and the FULL CHARGE (green) LED will stay on for longer periods of time as the battery becomes more fully charged. This is not applicable in the manual charge mode.

Using the Engine Start feature (model SI-1275A only)

Your battery charger can be used to jumpstart your car if the battery is low. Follow these instructions on how to use the ENGINE START feature.

Follow all safety instructions and precautions for charging your battery. Wear complete eye protection and clothing protection. Charge your battery in a well-ventilated area.

Using the ENGINE START feature WITHOUT a battery installed in the vehicle could cause damage to the vehicle’s electrical system. NOTE: If you have charged the battery and it still will not start your car, do not use the engine start feature, or it could damage the vehicle’s electrical system.

1.With the charger unplugged from the AC outlet, connect the charger to the battery following the instructions given in section 6 (FOLLOW THESE STEPS WHEN THE BATTERY IS INSTALLED IN A VEHICLE).

2.Plug the charger AC power cord into the AC outlet.

3.With the charger plugged in and connected to the battery of the vehicle, set the charge rate selector switch to the engine start position.

4.Crank the engine until it starts or 5 seconds pass. If the engine does not start, wait 4 minutes before cranking again. This allows the charger and battery to cool down.

NOTE: During extremely cold weather, or if the battery is under 2 volts, charge the battery for 5 minutes before cranking the engine.

5.If the engine fails to start, charge the battery for 5 more minutes before attempting to crank the engine again.

6.After the engine starts, move the charge rate selector switch to the OFF position and unplug the AC power cord before disconnecting the battery clips from the vehicle.

7.Clean and store the charger in a dry location.

NOTE: If the engine does turn over but never starts, there is not a problem with the starting system; there is a problem somewhere else with the vehicle. STOP cranking the engine until the other problem has been diagnosed and corrected.

• 42 •

Page 45 Page 47
Image 46
Page 45 Page 47
Contents Advertencia Aviso Page Sección Página Seção PáginaTable of contents Advertencia Riesgo DE Descarga Eléctrica O DE Incendio Riego DE Gases ExplosivosPage Page Precauciones Para LA Conexión DE CC Page Amperímetro a Instrucciones DE ArmadoPanel DE Control Porcentaje de cargaGEL AGMArranque de motores de 75 a modelo SI-1275A únicamente Instrucciones DE Funcionamiento Información DE LA BateríaFinalización de la carga carga automática únicamente Modo de mantenimiento carga automática únicamente12. Cómo Calcular EL Tiempo DE Carga Instrucciones DE MantenimientoResolución DE Problemas Causa Posible MOTIVO/SOLUCIÓN Instrucciones DE Traslado Y AlmacenamientoProblema Causa Posible MOTIVO/SOLUCIÓN Problema Causa Posible MOTIVO/SOLUCIÓN Antes DE Regresar Para LAS Reparaciones Placa de datos 230V, 50/60Hz Modelo Page Perigo Aviso Risco DE Choque Elétrico OU Fogo Risco DE Gases ExplosivosPrecauções Pessoais Preparação Para CargaPrecauções Para Conexão CC Posição do CarregadorRisco DE Explosão E Contato COM O Ácido DA Bateria UMA Faísca Próxima DASiga Estas Etapas Quando a Bateria Estiver Fora do Veículo Painel DE Controle Aterramento e conexões do fio elétrico de CAInstruções DE Montagem Porcentagem de cargaInterruptor para a seleção do tipo de bateria Instruções DE Operação Informações Sobre a BateriaTérmino da operação de carga somente carga automática Modo Manter somente carga automáticaInstruções DE Manutenção 12. Cálculo do Tempo DE CargaTAMANHO/TAXAS DA Bateria Taxa DE CARGA/TEMPO DE Carga Instruções DE Transporte E ArmazenamentoSolução DE Problemas Possível Causa MOTIVO/SOLUÇÃO Problema Possível Causa MOTIVO/SOLUÇÃO Verifique se há uma conexão Especificações Placa de informações Antes DE Devolver O Produto Para ReparoModelo SI-82-6MA Placa de informações 230 V, 50/60 Hz Modelo Page Page Risk of Electric Shock or Fire Risk of Explosive GasesPage Charger Location Risk of Explosion Contact with Battery Acid DC Connection PrecautionsPage Control Panel Grounding and AC power cord connectionsAssembly Instructions Ammeter aBattery Type Switch Charge Rate Selector Switch Voltage/Amp SelectorBattery Information Operating InstructionsUsing the Engine Start feature model SI-1275A only Maintain Mode Automatic Charge OnlyCompletion of Charge Automatic Charge Only Calculating Charge Time Battery SIZE/RATING Charge RATE/CHARGING TimeMaintenance Instructions Moving and Storage InstructionsTroubleshooting Problem Possible Cause REASON/SOLUTION Problem Possible Cause REASON/SOLUTION Specifications Data Plate 120V, 50/60Hz Model SI-82-6MA Before Returning for RepairsData Plate 230V, 50/60Hz Model

SI-82-6 specifications

The Schumacher SI-82-6 is a highly regarded battery charger, renowned for its efficiency and versatility in charging various types of batteries. This device is particularly popular among automotive enthusiasts, mechanics, and anyone in need of reliable battery maintenance.

One of the standout features of the SI-82-6 is its ability to charge multiple battery types, including lead-acid, gel, AGM, and deep-cycle batteries. This versatility ensures that it can cater to a wide array of vehicles, from cars and trucks to boats and recreational vehicles. The charger operates with a robust voltage rating, typically providing a perfect balance between power and safety.

The Schumacher SI-82-6 utilizes advanced microprocessor technology, which optimizes the charging process. This means that the charger not only delivers the appropriate voltage and current to the battery but also intelligently adjusts its performance during the charging cycle. This feature helps in reducing the risk of overcharging, thereby prolonging the lifespan of the battery.

Another significant advantage of the SI-82-6 is its automatic shut-off function. Once the battery is fully charged, the charger will automatically turn off, preventing any potential damage or overheating. This is a critical safety feature, particularly for those who may leave the charger unattended while it operates.

The SI-82-6 is designed with user convenience in mind. It features an easy-to-read LED display that provides real-time information on the charging status, allowing users to monitor the progress at a glance. The compact and portable design also makes it easy to store and transport, ensuring that it can be used wherever needed.

Furthermore, the charger comes equipped with reverse polarity protection, which safeguards both the charger and the battery from potential damage caused by incorrect connections.

In summary, the Schumacher SI-82-6 is a powerful and intelligent battery charger that combines efficiency with comprehensive safety features. Its ability to charge various battery types, coupled with automatic shut-off and user-friendly design, makes it a must-have tool for anyone looking to maintain their batteries effectively. With its solid construction and reliability, the SI-82-6 is a staple choice for both casual users and professional mechanics alike. Whether you are preparing your vehicle for a long drive or simply maintaining a backup battery, the Schumacher SI-82-6 stands out as a dependable solution.
Top Page Image Contents