Schumacher SI-82-6 owner manual Problem Possible Cause REASON/SOLUTION

Page 49

PROBLEM

POSSIBLE CAUSE

REASON/SOLUTION

The charger is making an

Circuit breaker is cycling.

The settings may be wrong.

audible clicking sound.

 

Check the charger settings.

 

Battery is defective.

Have the battery checked.

 

Shorted battery cables or

Circuit breaker cycles when

 

clips.

current draw is too high.

 

 

Check for shorted cables

 

 

or clips and replace if

 

 

necessary.

 

Severely discharged battery,

The battery may not want

 

but otherwise it is a good

to accept a charge due to

 

battery.

a run-down state. Allow

 

 

charging to continue until

 

 

battery has a chance to

 

 

recover sufficiently to take

 

 

a charge. If more than 20

 

 

minutes, stop charging and

 

 

have the battery checked.

 

Reverse connections at

Shut the charger off and

 

battery.

correct the lead connections.

Charger makes a loud buzz

Transformer laminations

No problem, this is a normal

or hum.

vibrate (buzz).

condition.

 

Shorted Diode Assembly or

Have charger checked by a

 

Output Rectifier Assembly

qualified technician.

 

(hum).

 

Short or no start cycle when

Drawing more than 75

Crank time varies with the

cranking engine.

amps.

amount of current drawn. If

 

 

cranking draws more than

 

 

75 amps, crank time may be

 

 

less than 5 seconds.

 

Failure to wait 4 minutes

Wait 4 minutes of rest time

 

(240 seconds) between

before the next crank.

 

cranks.

 

 

Clips are not making a good

Check for poor connection at

 

connection.

battery and frame.

 

AC cord and/or extension

Check power cord and

 

cord is loose.

extension cord for loose

 

 

fitting plug.

 

No power at receptacle.

Check for open fuse or

 

 

circuit breaker supplying AC

 

 

outlet.

 

The charger may be

The thermal protector may

 

overheated.

have tripped and needs a

 

 

little longer to reset. Make

 

 

sure the charger vents are

 

 

not blocked. Wait and try

 

 

again.

 

Battery may be severely

On a severely discharged

 

discharged.

battery, charge for 10 to

 

 

15 minutes in the 40 amp

 

 

manual rate to help assist in

 

 

cranking.

• 45 •

Page 48 Page 50
Image 49
Page 48 Page 50
Contents Advertencia Aviso Page Seção Página Sección PáginaTable of contents Advertencia Riego DE Gases Explosivos Riesgo DE Descarga Eléctrica O DE IncendioPage Page Precauciones Para LA Conexión DE CC Page Panel DE Control Instrucciones DE ArmadoAmperímetro a Porcentaje de cargaGEL AGMArranque de motores de 75 a modelo SI-1275A únicamente Información DE LA Batería Instrucciones DE FuncionamientoModo de mantenimiento carga automática únicamente Finalización de la carga carga automática únicamenteInstrucciones DE Mantenimiento 12. Cómo Calcular EL Tiempo DE CargaInstrucciones DE Traslado Y Almacenamiento Resolución DE Problemas Causa Posible MOTIVO/SOLUCIÓNProblema Causa Posible MOTIVO/SOLUCIÓN Problema Causa Posible MOTIVO/SOLUCIÓN Antes DE Regresar Para LAS Reparaciones Placa de datos 230V, 50/60Hz Modelo Page Perigo Aviso Risco DE Gases Explosivos Risco DE Choque Elétrico OU FogoPreparação Para Carga Precauções PessoaisRisco DE Explosão E Contato COM O Ácido DA Bateria Posição do CarregadorPrecauções Para Conexão CC UMA Faísca Próxima DASiga Estas Etapas Quando a Bateria Estiver Fora do Veículo Instruções DE Montagem Aterramento e conexões do fio elétrico de CAPainel DE Controle Porcentagem de cargaInterruptor para a seleção do tipo de bateria Informações Sobre a Bateria Instruções DE OperaçãoModo Manter somente carga automática Término da operação de carga somente carga automáticaTAMANHO/TAXAS DA Bateria Taxa DE CARGA/TEMPO DE Carga 12. Cálculo do Tempo DE CargaInstruções DE Manutenção Instruções DE Transporte E ArmazenamentoSolução DE Problemas Possível Causa MOTIVO/SOLUÇÃO Problema Possível Causa MOTIVO/SOLUÇÃO Verifique se há uma conexão Especificações Placa de informações Antes DE Devolver O Produto Para ReparoModelo SI-82-6MA Placa de informações 230 V, 50/60 Hz Modelo Page Page Risk of Explosive Gases Risk of Electric Shock or FirePage DC Connection Precautions Charger Location Risk of Explosion Contact with Battery AcidPage Assembly Instructions Grounding and AC power cord connectionsControl Panel Ammeter aCharge Rate Selector Switch Voltage/Amp Selector Battery Type SwitchOperating Instructions Battery InformationUsing the Engine Start feature model SI-1275A only Maintain Mode Automatic Charge OnlyCompletion of Charge Automatic Charge Only Maintenance Instructions Battery SIZE/RATING Charge RATE/CHARGING TimeCalculating Charge Time Moving and Storage InstructionsTroubleshooting Problem Possible Cause REASON/SOLUTION Problem Possible Cause REASON/SOLUTION Before Returning for Repairs Specifications Data Plate 120V, 50/60Hz Model SI-82-6MAData Plate 230V, 50/60Hz Model

SI-82-6 specifications

The Schumacher SI-82-6 is a highly regarded battery charger, renowned for its efficiency and versatility in charging various types of batteries. This device is particularly popular among automotive enthusiasts, mechanics, and anyone in need of reliable battery maintenance.

One of the standout features of the SI-82-6 is its ability to charge multiple battery types, including lead-acid, gel, AGM, and deep-cycle batteries. This versatility ensures that it can cater to a wide array of vehicles, from cars and trucks to boats and recreational vehicles. The charger operates with a robust voltage rating, typically providing a perfect balance between power and safety.

The Schumacher SI-82-6 utilizes advanced microprocessor technology, which optimizes the charging process. This means that the charger not only delivers the appropriate voltage and current to the battery but also intelligently adjusts its performance during the charging cycle. This feature helps in reducing the risk of overcharging, thereby prolonging the lifespan of the battery.

Another significant advantage of the SI-82-6 is its automatic shut-off function. Once the battery is fully charged, the charger will automatically turn off, preventing any potential damage or overheating. This is a critical safety feature, particularly for those who may leave the charger unattended while it operates.

The SI-82-6 is designed with user convenience in mind. It features an easy-to-read LED display that provides real-time information on the charging status, allowing users to monitor the progress at a glance. The compact and portable design also makes it easy to store and transport, ensuring that it can be used wherever needed.

Furthermore, the charger comes equipped with reverse polarity protection, which safeguards both the charger and the battery from potential damage caused by incorrect connections.

In summary, the Schumacher SI-82-6 is a powerful and intelligent battery charger that combines efficiency with comprehensive safety features. Its ability to charge various battery types, coupled with automatic shut-off and user-friendly design, makes it a must-have tool for anyone looking to maintain their batteries effectively. With its solid construction and reliability, the SI-82-6 is a staple choice for both casual users and professional mechanics alike. Whether you are preparing your vehicle for a long drive or simply maintaining a backup battery, the Schumacher SI-82-6 stands out as a dependable solution.
Top Page Image Contents