01_KS3682_EN.fm Page 16 Friday, February 12, 2010 12:26 PM
This air clean filter cannot remove harmful gases or vapors nor ventilate air in the room. You must open doors or windows frequently when you use gas or oil heating appliances. Otherwise there is a risk of suffocation in extreme cases.
How to install the air clean filter
Remounting
Grasp the sections near the front panel arms on both sides, and hold the front panel so that it is nearly horizontal. Push the arm shafts towards the outside so that they come into contact with the top of the indentations on the right and left sides of the air conditioner. Then push firmly until the arm shafts click into place. After closing the front panel, press firmly on the parts indicated by the arrows to securely fasten the panel in place.
Also refer to the figure that shows “How to replace the
The air clean filter needs to be installed behind the
CAUTION
When using a footstool or the like, be careful not to let it tip over.
Air clean filter
Air filter holder
1.Open the front panel and remove the
2.Remove the air filter holder from the
3.Install the air clean filter in the air filter holder.
4.Install the air filter holder to the
How to clean the air clean filter
•In general, the filter should be sucked to remove dust in low fan speed of a vacuum cleaner once every three months.
•If there is heavily grime on the filter, soak the filter in lukewarm water with neutral detergent diluted 1:500 for 1 to 2 minutes then wash it.
•Rinse the filter in clean water, then let it dry on the towel in room temperature.
NOTE
•Do not bend nor give excessive force onto the air clean filter.
•If the filter surface is heavily blocked with dirt or damaged, replace it with new one. Purchase a replacement filter at your local dealer. (model
Cleaning the main unit and remote control unit
•Wipe clean using a soft, dry cloth.
•To remove stubborn dirt, moisten a cloth in warm water no hotter than 104 °F, wring thoroughly, and then wipe.
•The front panel can be removed in order to wash it with water.
Removing and remounting the front panel
Removing
Open the front panel until it is nearly horizontal, grasp the sections near the front panel arms on both sides, and then remove the panel by pushing the arms towards the outside while pulling the panel towards you.
If the front panel is difficult to remove, grasp both ends of it and lift it up slightly.
Move it to the left and disengage the left arm, then move it to the right and disengage the right arm.
Front panel | Arm |
Washing the front panel with water
•Clean the front panel gently using a soft sponge, or the like. Then wipe away any remaining moisture.
•Neutral detergent may be used to remove stubborn dirt. Then rinse thoroughly with water and wipe away any remaining moisture.
16 | |
|