ASSEMBLY
Mount wall mountings and rail
There are two types of wall mounting available for the Husqvarna WS 400 series. One, the standard wall mounting, which is supplied on delivery, and secondly the universal swivel wall mounting.
IMPORTANT! The Husqvarna WS 400 series may only be used with the two wall mountings described above. Older Husqvarna wall mountings are similar to the new standard wall mounting, but have a longer base. This mounting must not be used with the WS 400 series as there is a risk that the arm catches on the base of the mounting.
Use the universal wall mounting when cutting doors, cutting flush, cutting at angles and stair cutting as well as groove cutting. If you only require an everyday straight cut you use the fixed mounting.
Fit the universal wall mounting for the required cutting method (See the separate manual).
Fit the standard wall mounting as set out below:
1Mark off the cutting line and mark off the expander bolts holes 165 mm (6.5") from the cutting line.
2Drill 15 mm (5/8”) holes for the M12 (1/2”) expander bolts.
3Hang the wall mountings loosely from the expander bolts, using M6S 12 x 70 (1/2”x2”) or similar.
4Place the rail in the wall mountings and tighten the compression washers.
5Check that the rail is properly aligned with the tracks on the wall mounts before tightening the screws.
6Adjust the distance between the cutting line and the wall mounting. The distance between the edge and the inner face of the saw cut should be 89 mm (3.5"). Tighten the expander bolts.
IMPORTANT! Only use the connectors supplied when purchasing the saw as older connectors are not designed for the WS 400 series.
English – 9