Western Telematic CMS-16 manual Display

WTI CMS-16; Console Management Switch -- User's Guide

. Cable Connection: Check the connection between the CMS and the PC. Make certain the cable connectors are firmly seated.

b.Communication Parameters: Make certain the CMS and ProComm are using the same baud rate.

4.Help Screen: Type /H [Enter] to display the Supervisor Level Help Screen (Figure 3.1).

DISPLAY	Port	Status	CONFIGURATION
/S[P]			/F	System Parameters
/SD	Port	Diagnostics	/P [n] Port Parameters
/W[P] [n]	Port	Parameters (Who)	/N	Network Parameters
/J	Site ID		/I	Default & Test
/SN	Network Status		/UF	Upgrade Firmware
/H	Command Menu (Help)		/CP	Copy Port
Parameters
CONTROL		Enter Command Mode	+-----------------------+
<Enter>
/X		Exit Command Mode	n	Port # or Name
/C <n> [n]	*>	Connect Local [Remote]	*	All
/D <n ...		Disconnect		"or"
/E <n ...	*>	Erase Buffer	<>	Required Entry
/U		Send Parameter File	[]	Optional Entry
/T		Reset Network Interface	+-----------------------+
/D, /E, /I, /T Commands: Add /Y to bypass			"Sure (Y/N)?"
Figure 3.1: The Supervisor Level Help Screen

5.Port Status Screen: Type /S [Enter] to display the Port Status Screen (Figure 3.2), which summarizes conditions at all Ports. The various fields of the Port Status Screen are explained in Section 6.1.

PORT		NAME		PASSWORD	STATUS MODE BUFFER COUNT
-----+		------------------	+	------------------	+	--------Free	+------	+	--------------0
01	(undefined)		(undefined)				Any
02	(undefined)		(undefined)			Free	Any		0
03	(undefined)		(undefined)			Free	Any		0
04	(undefined)		(undefined)			Free	Any		0
05	(undefined)		(undefined)			Free	Any		0
06	(undefined)		(undefined)			Free	Any		0
07	(undefined)		(undefined)			Free	Any		0
08	(undefined)		(undefined)			Free	Any		0
09						Free			0
	(undefined)		(undefined)				Any
10	(undefined)		(undefined)			Free	Any		0

file:///C/WEBPAGE/guides/cms/html/rev_b/Cmsguide.htm (11 of 59) [11/15/2000 10:52:02 AM]