WTI CMS-16; Console Management Switch -- User's Guide
command is invoked, the network connection will be reset without warning, and must then be
Availability: Supervisor Only
Format: /T [Enter]
Response: None (NIC Card is reset, Network Connection is broken)
/U Save Parameters
Sends CMS configuration parameters to an ASCII text file as described in Section 8.
Availability: Supervisor Only
Format: /U [Enter]
Response: The CMS will send a series of command lines.
/UF Upgrade Firmware
When new versions of the CMS operating firmware become available, this command is used to update the existing firmware as described in Section 9. Note that this command will only function at the Network Port and at Setup Ports One and Two.
Availability: Supervisor Only
Format: /UF [Enter]
Response: The CMS will display a menu which offers the options to retain existing CMS parameters, default parameters, or abort the upgrade procedure.
/W Display Port Parameters (Who)
Displays configuration of an individual port, but does not allow the user to change parameters. Ports with User Level command capability cannot display parameters for other ports. Normally, the Port Parameters screen will not include the Port Password. Note however, that when the Supervisor Mode is active, the /WP option can be used to display the password for the target port. For more information, please refer to Section 6.4.
Availability: Supervisor / User
Format: /W[P] [x] [Enter]
Where:
PWhen the "P" option is included (e.g. /WP 5), the Port Parameters screen will list the password for each port, if defined. (Supervisor Mode Only).
xIs the port number or name. To display parameters for the Network Port, enter an "N". If the "x" argument is omitted, parameters for your resident port will be displayed.
file:///C/WEBPAGE/guides/cms/html/rev_b/Cmsguide.htm (56 of 59) [11/15/2000 10:52:03 AM]