HP StudioJet manual Installing the Take-up Shaft, FlexJet E only

32 Ioline FlexJet E User Guide

CAUTION

Never touch the take-up key or flanged coupling while they are rotating.

Serious personal injury could re-

sult.Turn

power off

first.

Installing the Take-up Shaft

(FlexJet E only)

The Paper Out sensor on the back of the printer detects when the paper runs out. If paper isn’t loaded or if the take-up key is not posi- tioned properly, place a small piece of masking tape over the Paper Out sensor before following the steps below. Remove the tape after the take-up key is properly positioned before installing paper.

1.If the take-up shaft has plotted markers on it, remove them. See Removing Markers from the Take-up Shaft later in this chapter.

2.Turn the printer on (the switch is on the back of the left cover.)

3.Use the keypad Unroll key to rotate the take-up key until it is oriented perpendicular to the support block opening as shown in Figure 19.

4.Put the take-up shaft into the front support blocks with the flanged coupling at the right (keypad) end. Rotate the shaft until the slot in the flanged coupling is aligned with the take- up key. When the shaft slot and the key are aligned, push the

Rectangular slot

Take-up	Flanged
Shaft	Coupling

Position take-up key as shown

Support Block

Figure 19. Installing the take-up shaft in the support blocks.