HP StudioJet, FlexJet E manual Quick Start Guide to level

Jagged scan alignment.

Cause:		Solution:
1.	Motion alignment is incorrect.	1.	Use the Control Center to ad-
			just motion alignment as shown
			in the Routine Maintenance
			chapter.
2.	Platen or stand is not level.	2.	Follow the directions in the
			FlexJet E Printer or StudioJet
			Quick Start Guide to level the
3.	Loose carriage pulley causing ran-		stand and platen.
	dom/uneven gaps between scans.	3.	Contact Ioline customer service.
Poor paper tracking.
Cause:		Solution:
1.	Paper is improperly loaded.	1.	Reload and align paper.
2.	Bad paper roll or paper quality.	2.	Replace the paper roll.
3.	Pinchwheels not in correct	3.	Reposition the pinchwheels
	location.		as indicated in the Operation
			chapter.
4	Feed paper roll is centered on	4.	Center the paper roll on feed shaft
	feed shaft.		(see Figure 16). Make sure screws
			are tight on both paper hubs.
5.	Paper roll not centered on feed	5.	Ensure the feed roll is centered
	shaft.		on the feed shaft.
6.	Loose paper hubs.	6.	Tighten screws on the paper hubs.

Gap between each scan.

Chapter 5:Troubleshooting 55

Cause:

1.Frame Gap setting is incorrect.

2.Ink cartridge is out of ink, dirty or the print head is plugged.

Solution:

1.Use the Control Center to adjust frame gap as shown in the Routine Maintenance chapter.

2.Check ink level indicator. Replace cartridge if indicator is black. If cartridge is not empty, see Cartridge Maintenance and Handling under the Rou- tine Maintenance chapter.

Pauses during printing.

Cause:

1.Vector density is very high due to fine detail or the design soft- ware is not using fonts embed- ded in the printer.

2.Communication baud rate is set very low.

Solution:

1.Reduce vector density, use em- bedded printer fonts, or increase communication baud rate.

2.Increase baud rate from the minimum of 9600 baud to the default of 38,400 or higher.