HP T3204 manual Loading media

Page 19

loading media

13To use the media rewind hub, complete the following procedure.

a.Lower the lower right-hand front panel.

b.Remove the arc plate from its stored position, and install on the front of

the printer.

Route the media around the arc plate and to the media rewinder.

c. Place the clasp over the end of the media, and rotate the media rewinder a few turns.

Rotate the media guide up, and slide it to the media edge.

d.Lift and snap the lower right-hand front panel closed.

Continue with step 14.

14Raise the hinge plate, and lower the printhead by rotating the printhead latch clockwise to the latched position.

15Close the media supply door.

16Press ON LINE/PAUSE to enable printing.

note

It may be necessary to feed several labels before proper alignment of the media occurs.

Operator's Guide

11

Image 19

Contents GG GG Page 136578±001, Rev B US and Canada Radio Interference Note Ri rrkTrademarks About thi Opertor Guide Table of ontents Basic Operating ProceduresPage Aution Powering On the PrinterStatus Indicator Lights Using the primary operator panelCancel On LINE/PAUSE Printing Modes Loading Media Metal HUB Loading mediaTo load fan±folded media, proceed as follows Printhead Media Hinge Latch Guide Plate Noe Loading media Loading media Loading media Unloading Media Unloading media Right-Hand Front Panel Installing the Ribbon Installing the ribbon Hook Removing the Ribbon Removing the ribbon Printhead Hinge Latch Plate Selecting Print Mode Selecting Gap Sensor Setting Print Intensity Slctin Mia Hanlin To enter the media handling To view the desired Selecting media handlingSelecting the Ribbon Saver Leaning the Printer Cleaning the Outside of the CabinetCleaning the printer Prom Fault Fault MessagesMedia Fault Fault messagesPage 6662