HP T3204 manual Unloading Media

Page 22

Unloading Media

Use the following procedure to unload media from the printer.

1Press ON LINE/PAUSE to place the

printer in the off line mode.

Open the media supply door.

2Rotate the printhead latch counterclockwise to unlatch, and raise the printhead to an upright position.

3Lower the hinge plate down. Slide the media guide to the outer edge, and

rotate it to the down position.

4Cut the media either before or after the front slot, depending on whether or not the rewind hub is being used.

no￿e

If the media rewind hub was being used, you may choose to continue winding the media onto the hub or to roll it back onto the supply roll (media hub).

5If the installed media is fan±folded, skip the next step and go on to step 7.

Otherwise, continue with step 6.

14

Media

Supply

Window

Media

Supply Door

Printhead

Media

Hinge

Latch

Guide

Plate

Operator's Guide

Page 21 Page 23
Image 22
Page 21 Page 23
Contents GG GG Page 136578±001, Rev B Ri rrk US and Canada Radio Interference NoteTrademarks About thi Opertor Guide Basic Operating Procedures Table of ontentsPage Powering On the Printer AutionUsing the primary operator panel Status Indicator LightsCancel On LINE/PAUSE Printing Modes Loading Media Loading media Metal HUBTo load fan±folded media, proceed as follows Printhead Media Hinge Latch Guide Plate Noe Loading media Loading media Loading media Unloading Media Unloading media Right-Hand Front Panel Installing the Ribbon Installing the ribbon Hook Removing the Ribbon Removing the ribbon Printhead Hinge Latch Plate Selecting Print Mode Selecting Gap Sensor Setting Print Intensity Slctin Mia Hanlin Selecting media handling To enter the media handling To view the desiredSelecting the Ribbon Saver Cleaning the Outside of the Cabinet Leaning the PrinterCleaning the printer Fault Messages Prom FaultFault messages Media FaultPage 6662
Top Page Image Contents