HP T3204 manual Loading Media

Page 14

Loading Media

The printer accepts a wide range of media. It can be loaded with roll±fed, fan±folded, or die±cut continuous media of either thermal transfer or direct thermal type. Media width can range from 0.75 inches (19.1 mm) to 4.65 inches (118.1 mm). Media thickness can range from 0.0025 inches (0.0635 mm) to 0.01 inches (0.254 mm).

Use the following procedures to load media of various kinds into the printer.

1Press ON LINE/PAUSE to place the printer in the off line mode.

Open the media supply door.

2 Rotate the printhead latch counterclockwise to unlatch, and raise the printhead to an upright position.

3Lower the hinge plate down. Slide the media guide to the outer edge, and rotate it to the down position.

4If you are loading fan±folded media, skip the next step and go on to step 6.

5To load roll±fed media, continue as follows:

Media

Supply

Window

Media

Supply Door

Printhead

Media

Hinge

Latch

Guide

Plate

6

Operator's Guide

Page 13 Page 15
Image 14
Page 13 Page 15
Contents GG GG Page 136578±001, Rev B Ri rrk US and Canada Radio Interference NoteTrademarks About thi Opertor Guide Basic Operating Procedures Table of ontentsPage Powering On the Printer AutionUsing the primary operator panel Status Indicator LightsCancel On LINE/PAUSE Printing Modes Loading Media Loading media Metal HUBTo load fan±folded media, proceed as follows Printhead Media Hinge Latch Guide Plate Noe Loading media Loading media Loading media Unloading Media Unloading media Right-Hand Front Panel Installing the Ribbon Installing the ribbon Hook Removing the Ribbon Removing the ribbon Printhead Hinge Latch Plate Selecting Print Mode Selecting Gap Sensor Setting Print Intensity Slctin Mia Hanlin Selecting media handling To enter the media handling To view the desiredSelecting the Ribbon Saver Cleaning the Outside of the Cabinet Leaning the PrinterCleaning the printer Fault Messages Prom FaultFault messages Media FaultPage 6662
Top Page Image Contents