HP T3204 manual Powering On the Printer, Aution

Page 9

Powering On the Printer

￿aution

Before powering on the printer, make sure it is plugged into the appropriate power source.

Refer to the ªSelect a Siteº section in Chapter 2 of the Setup Guide for information on proper power sources.

The power switch is located on the lower right±hand corner of the rear of the printer. It is marked f for power OFF and for power ON.

For help with diagnosing printer problems, printer self±test routines are automatically run during the power±on cycle. Further diagnostic tests can be performed using the secondary operator panel functions. They are covered in detail in the Setup Guide.

Using the Primary Operator Panel

AC Power

Switch

AC Power Connector

Fuse

Holder

Use the primary operator panel to perform routine operations. The panel contains three operator-accessible keys and three indicator lights, used to control and indicate printer status.

not￿

The functions and meanings of some of the keys and indicators on the primary operator panel will change depending on the firmware installed. This manual describes printer operation with Printronix LP+, IGP/PGL or IGP/VGL emulation firmware installed. If your printer has Printronix IGP/FGL emulation firmware, please refer to the T3306 and T3308 Label Printers Operator's Guide, p/n 136452±001.

There is also a secondary operator panel, consisting of a message display and six keys. This panel is used to configure the printer and to run self±tests, via the configuration menus.

Message

Display

Primary

Control

Panel

Message

Display

Contrast

Adjust

Secondary

Control

Panel

Operator's Guide

1

Image 9
Contents GG GG Page 136578±001, Rev B US and Canada Radio Interference Note Ri rrkTrademarks About thi Opertor Guide Table of ontents Basic Operating ProceduresPage Aution Powering On the PrinterStatus Indicator Lights Using the primary operator panelCancel On LINE/PAUSE Printing Modes Loading Media Metal HUB Loading mediaTo load fan±folded media, proceed as follows Printhead Media Hinge Latch Guide Plate Noe Loading media Loading media Loading media Unloading Media Unloading media Right-Hand Front Panel Installing the Ribbon Installing the ribbon Hook Removing the Ribbon Removing the ribbon Printhead Hinge Latch Plate Selecting Print Mode Selecting Gap Sensor Setting Print Intensity Slctin Mia Hanlin To enter the media handling To view the desired Selecting media handlingSelecting the Ribbon Saver Leaning the Printer Cleaning the Outside of the CabinetCleaning the printer Prom Fault Fault MessagesMedia Fault Fault messagesPage 6662