HP T3204 manual Selecting Gap Sensor

Page 32

Selecting Gap Sensor

GAP SENSOR selects the type of media used for printing. The options for this selection are as follows:

•TRANSMISSIVE (see±through)

•REFLECTIVE (black stripe)

•NONE (default)

1Press ON LINE/PAUSE to place the printer in the off line mode.

OFFLINE IGP/PGL

2Press to enter the configuration menus.

3Press to reach the printer control menu.

4Press to enter the printer control menu.

5 Press

to reach the gap sensor

menu.

 

6Press to enter the gap sensor menu.

7 Press

to view the desired setting.

8Press ENTER to select the setting.

9Press ON LINE/PAUSE to place the printer in the on line mode.

USER CONFIG PAPER CONTROL

USER CONFIG PRINTER CONTROL

PRINTER CONTROL

Media Handling

PRINTER CONTROL Gap Sensor

Gap Sensor

None *

Gap Sensor

None *

Gap Sensor

Reflective

Gap Sensor

Transmissive

Gap Sensor

Reflective *

ONLINE

IGP/PGL

24

Operator's Guide

Page 31 Page 33
Image 32
Page 31 Page 33
Contents GG GG Page 136578±001, Rev B Ri rrk US and Canada Radio Interference NoteTrademarks About thi Opertor Guide Basic Operating Procedures Table of ontentsPage Powering On the Printer AutionUsing the primary operator panel Status Indicator LightsCancel On LINE/PAUSE Printing Modes Loading Media Loading media Metal HUBTo load fan±folded media, proceed as follows Printhead Media Hinge Latch Guide Plate Noe Loading media Loading media Loading media Unloading Media Unloading media Right-Hand Front Panel Installing the Ribbon Installing the ribbon Hook Removing the Ribbon Removing the ribbon Printhead Hinge Latch Plate Selecting Print Mode Selecting Gap Sensor Setting Print Intensity Slctin Mia Hanlin Selecting media handling To enter the media handling To view the desiredSelecting the Ribbon Saver Cleaning the Outside of the Cabinet Leaning the PrinterCleaning the printer Fault Messages Prom FaultFault messages Media FaultPage 6662
Top Page Image Contents