HP T3204 manual Loading media

Page 21

loading media

g.Route the media liner (backing) around the tear bar to the media rewinder.

h.Place the clasp over the end of the media, and rotate the media rewinder a few turns.

. Rotate the media guide up, and slide it to the media's edge.

j.Lift and snap the lower right front panel closed.

k.Raise the hinge plate, and latch the printhead by rotating the printhead latch clockwise to the latched position.

l.Close the side cover.

note

It is possible to use the present sensor only (without inverting the tear bar) to provide on-demand label printing in the tear-off mode. To operate in this mode, media should be routed as shown in step f, and the Label Present menu selection should be enabled.

Operator's Guide

13

Image 21

Contents GG GG Page 136578±001, Rev B US and Canada Radio Interference Note Ri rrkTrademarks About thi Opertor Guide Table of ontents Basic Operating ProceduresPage Aution Powering On the PrinterStatus Indicator Lights Using the primary operator panelCancel On LINE/PAUSE Printing Modes Loading Media Metal HUB Loading mediaTo load fan±folded media, proceed as follows Printhead Media Hinge Latch Guide Plate Noe Loading media Loading media Loading media Unloading Media Unloading media Right-Hand Front Panel Installing the Ribbon Installing the ribbon Hook Removing the Ribbon Removing the ribbon Printhead Hinge Latch Plate Selecting Print Mode Selecting Gap Sensor Setting Print Intensity Slctin Mia Hanlin To enter the media handling To view the desired Selecting media handlingSelecting the Ribbon Saver Leaning the Printer Cleaning the Outside of the CabinetCleaning the printer Prom Fault Fault MessagesMedia Fault Fault messagesPage 6662