HP T3204 manual Loading media

Page 20

loading media

17The peel-and-presentoption allows for on-demand label dispensing. Although the peel-and-present mechanism is included with every printer, the label present sensor and internal rewind options are required to use this feature. To use the optional peel-and-present, follow the instructions outlined below.

a.Turn off the printer, and open the side access cover.

b.Rotate the printhead latch counterclockwise to raise the printhead.

c.Lower the hinge plate and the lower front panel.

d.Using a Philips screwdriver, remove the tear bar, invert it (flip it over), and reinstall it.

e.Place the media supply roll on the media hub assembly. Slide the media retainer against the supply roll, and tighten the thumbscrew.

f.Route the media over the guide plate, through the media sensor, and over the platen roller (located beneath the printhead).

12

Operator's Guide

Image 20
Contents GG GG Page 136578±001, Rev B Ri rrk US and Canada Radio Interference NoteTrademarks About thi Opertor Guide Basic Operating Procedures Table of ontentsPage Powering On the Printer AutionUsing the primary operator panel Status Indicator LightsCancel On LINE/PAUSE Printing Modes Loading Media Loading media Metal HUBTo load fan±folded media, proceed as follows Printhead Media Hinge Latch Guide Plate Noe Loading media Loading media Loading media Unloading Media Unloading media Right-Hand Front Panel Installing the Ribbon Installing the ribbon Hook Removing the Ribbon Removing the ribbon Printhead Hinge Latch Plate Selecting Print Mode Selecting Gap Sensor Setting Print Intensity Slctin Mia Hanlin Selecting media handling To enter the media handling To view the desiredSelecting the Ribbon Saver Cleaning the Outside of the Cabinet Leaning the PrinterCleaning the printer Fault Messages Prom FaultFault messages Media FaultPage 6662