HP T3204 manual Printhead Hinge Latch Plate

Page 30

removing the ribbon

6Slide the used ribbon off the hub, and dispose of it.

7Turn the ribbon supply hub clockwise to draw the unused portion of the ribbon back onto the supply roll.

note

You may leave the unused portion of the ribbon in place until the next thermal transfer print job, at which time you may reinstall it by following the ribbon installation procedure.

8Raise the hinge plate, and lock the printhead by rotating the printhead latch clockwise.

9Close the media supply door.

10Press ON LINE/PAUSE to enable printing.

Printhead	Hinge
Latch	Plate

22	Operator's Guide

Image 30

Contents GG GG Page 136578±001, Rev B Ri rrk US and Canada Radio Interference NoteTrademarks About thi Opertor Guide Basic Operating Procedures Table of ontentsPage Powering On the Printer AutionUsing the primary operator panel Status Indicator LightsCancel On LINE/PAUSE Printing Modes Loading Media Loading media Metal HUBTo load fan±folded media, proceed as follows Printhead Media Hinge Latch Guide Plate Noe Loading media Loading media Loading media Unloading Media Unloading media Right-Hand Front Panel Installing the Ribbon Installing the ribbon Hook Removing the Ribbon Removing the ribbon Printhead Hinge Latch Plate Selecting Print Mode Selecting Gap Sensor Setting Print Intensity Slctin Mia Hanlin Selecting media handling To enter the media handling To view the desiredSelecting the Ribbon Saver Cleaning the Outside of the Cabinet Leaning the PrinterCleaning the printer Fault Messages Prom FaultFault messages Media FaultPage 6662