HP T3204 manual Removing the Ribbon

Page 28

Removing the Ribbon

Generally, ribbons are used to completion and then replaced. Removal of the old ribbon is simply a matter of pulling it off the take±up hub and discarding it.

However, there may be times when the use of direct thermal media is required and an installed ribbon has not been completely used up. (As noted previously, when printing in direct thermal mode, the printer does not use a ribbon.)

In this case, use the following procedure to remove the ribbon.

not￿

The direct thermal mode is selected through the printer menu system. The main menu is accessed via the secondary operator panel. Refer to the ªConfiguring the Printerº chapter in the Setup Guide for complete instructions in how to access and use the secondary operator panel.

1Press ON LINE/PAUSE to place the printer in the off line mode.

2Open the media supply door.

20

Media

Supply

Window

Media

Supply Door

Operator's Guide

Page 27 Page 29
Image 28
Page 27 Page 29
Contents GG GG Page 136578±001, Rev B Ri rrk US and Canada Radio Interference NoteTrademarks About thi Opertor Guide Basic Operating Procedures Table of ontentsPage Powering On the Printer AutionUsing the primary operator panel Status Indicator LightsCancel On LINE/PAUSE Printing Modes Loading Media Loading media Metal HUBTo load fan±folded media, proceed as follows Printhead Media Hinge Latch Guide Plate Noe Loading media Loading media Loading media Unloading Media Unloading media Right-Hand Front Panel Installing the Ribbon Installing the ribbon Hook Removing the Ribbon Removing the ribbon Printhead Hinge Latch Plate Selecting Print Mode Selecting Gap Sensor Setting Print Intensity Slctin Mia Hanlin Selecting media handling To enter the media handling To view the desiredSelecting the Ribbon Saver Cleaning the Outside of the Cabinet Leaning the PrinterCleaning the printer Fault Messages Prom FaultFault messages Media FaultPage 6662
Top Page Image Contents