Setting Print Intensity
The PRINT INTENSITY adjustment is used to balance a new printhead, so that it prints at the same level of darkness as did the previous head. You can specify intensity values from ±10 through +10. The factory default setting is 0.
1Press ON LINE/PAUSE to place the printer in the off line mode.
2Press 
to enter the configuration menus.
3Press 
to reach the printer control menu.
4Press 
to enter the printer control menu.
5 Press | to reach the print |
intensity menu. |
|
6Press 
to enter the print intensity menu.
7 Press | to select the desired |
value. |
|
8Press ENTER to select the setting.
9Press ON LINE/PAUSE to place the printer in the on line mode.
Operator's Guide
OFFLINE
IGP/PGL
USER CONFIG
PAPER CONTROL
USER CONFIG
PRINTER CONTROL
PRINTER CONTROL
Media Handling
PRINTER CONTROL
Print Intensity
Print Intensity
0*
Print Intensity ±10
Print Intensity
0*
Print Intensity
10
Print Intensity ±3
ONLINE
IGP/PGL
25