Toshiba RAM-SM560KRT-E Central indication, Set up temp. button, Louver operation button

Operation section

Push each button to select a desired operation.

1

2

3

4

5

Operation select button

Selects desired operation mode.

Air volume select button

Selects the desired air volume mode

Set up temp. button

Adjusts the required room temperature.

Match to the desired set temperature by

pushing .

Filter reset button

Resets (Erases) “FILTER” display.

CHECK button

When an error/fault occurs on the air conditioner, this button is used to check the check code indicating fault status.

6 Operation lamp

Lamp is lit during the operation.

Lamp is off when stopped.

Although it flashes when power switch is turned on or when turned on again after power failure, it goes on if the operation has started.

7 Louver operation button

With auto louver function, the discharge louver operates or stops during operation of air condi- tioner.

8 ON/OFF button

When the button is pushed, the operation starts, and it stops by pushing the button again.

When the operation has stopped, the operation lamp and louver display disappear though other displays remain as they are.

“Central indication”

When using a remote controller connected to a central remote controller, etc., contents which can be operated by the standard remote controller and “CENTRAL” display change by setting at the central remote controller.

Setup on central remote controller

Last-push priority

(No display)

“CENTRAL” display on

standard remote controller

Goes off

Contents operated by standard remote controller

Operated from both standard remote controller and central remote controller, and operated with contents specified later.

Center

Goes on

ON / OFF only can be operated.

Operation inhibit

Flashes

Cannot be operated.

For application control using other “Weekly timer” or “Central remote controller” other than this standard remote controller, refer to the Manual attached to each remote controller.

83