HP C7250, C7288, C7280 manual Dial Tone Detection test failed

Page 60

Chapter 5

2

Phone cord supplied in the box with the HP All-in-One

•Check the connection between the telephone wall jack and the HP All-in-One to make sure the phone cord is secure.

Troubleshooting and support

The "Dial Tone Detection" test failed

Solution

•Other equipment, which uses the same phone line as the HP All-in-One, might be causing the test to fail. To find out if other equipment is causing a problem, disconnect everything except the HP All-in-One from the phone line, and then run the test again. If the Dial Tone Detection Test passes without the other equipment, then one or more pieces of the equipment is causing problems; try adding them back one at a time and rerunning the test each time, until you identify which piece of equipment is causing the problem.

•Try connecting a working phone and phone cord to the telephone wall jack that you are using for the HP All-in-One and check for a dial tone. If you do not hear a dial tone, contact your telephone company and have them check the line.

•Make sure you have correctly connected the HP All-in-One to the telephone wall jack. Using the phone cord supplied in the box with the HP All-in-One, connect one end to your telephone wall jack, then connect the other end to the port labeled 1-LINE on the back of the HP All-in-One.

1Telephone wall jack

2Use the phone cord supplied in the box with the HP All-in-One

•If you are using a phone splitter, this can cause faxing problems. (A splitter is a two-cord connector that plugs into a telephone wall jack.) Try removing the splitter and connecting the HP All-in-One directly to the telephone wall jack.

•If your telephone system is not using a standard dial tone, such as some PBX systems, this might cause the test to fail. This will not cause a problem sending or receiving faxes. Try sending or receiving a test fax.

58 Troubleshooting and support

Image 60

Contents

HP Photosmart C7200 All-in-One series Hewlett-Packard Company notices Contents Troubleshooting and support Technical informationHP All-in-One overview HP All-in-One at a glanceControl panel features One overviewLabel Name and Description Setup Guide Find more informationOnscreen Help Network setup Wired network setupWhat you need for a wired network Connect the HP All-in-One to the networkTo connect the HP All-in-One to the network Integrated wireless Wlan 802.11 network setup What you need for an integrated wireless Wlan 802.11 network Connect to an integrated wireless Wlan 802.11 networkTo connect the HP All-in-One with the Wireless Setup Wizard If you do not see your network name in the listWireless ad hoc network setup To connect the HP All-in-One with SecureEasySetupWhat you need for an ad hoc network Create a network profile for a Windows XP computerConnect to a wireless ad hoc network Communication mode Ad Hoc Encryption enabledTo connect to a wireless ad hoc network Create a network profile for other operating systemsPress to highlight Wireless Setup Wizard, and then press OK Install the software for a network connection To install the Windows HP All-in-One softwareConnect to additional computers on a network Manage your network settings Change basic network settings from the control panelTo change a USB connection to a wired Ethernet connection Use the Wireless Setup Wizard View and print network settingsRestore network defaults Turn the wireless radio on and offPrint the wireless network test Change IP settingsSet link speed Automatic Full HalfIP Address Subnet Mask Default Gateway Fax setup Set up the HP All-in-One for faxingCase a Separate fax line no voice calls received Case B Set up the HP All-in-One with DSL To set up the HP All-in-One with a separate fax lineTo set up the HP All-in-One with DSL Case D Fax with a distinctive ring service on the same line To set up the HP All-in-One with a distinctive ring service Case E Shared voice/fax lineTo set up the HP All-in-One with a shared voice/fax line Case F Shared voice/fax line with voice mailChange settings on the HP All-in-One to receive faxes Set the answer modeTo set up the HP All-in-One with voice mail To set the answer mode Set the number of rings before answeringChange the answer ring pattern for distinctive ringing Test your fax setup To test your fax setup from the control panelTo set a default fax header from the control panel Set the fax headerSet the fax header Load originals and load paper Load an original in the automatic document feederTo load an original in the document feeder tray Load an original on the glass Load full-size paperTo load an original on the scanner glass To load full-size paperChapter Load 10 x 15 cm 4 x 6 inch photo paper To load 10 x 15 cm 4 x 6 inch photo paper in the photo trayAvoid paper jams View and select photosTo view, select, and print photos Scan an image Scan an original to a computerScan an original to a memory card or storage device Make a copy Send a basic faxTo save a scan to a memory card or storage device To make a copy from the control panelCheck the estimated ink levels To send a basic fax from the control panelPress Fax Menu To check the ink levels from the control panelReplace the ink cartridges To replace the ink cartridgesUse HP All -in One features Clean the HP All-in-One Clean the glassTo clean the glass Clean the lid backing To clean the lid backing Uninstall and reinstall the software Hardware setup troubleshootingHP All-in-One will not turn on Solution Display shows the wrong language Wrong measurements are showing in menus on the displayTo set your language and country/region Network troubleshooting Wired network setup troubleshootingHP All-in-One does not print Printer not Found screen appears during installation Computer is unable to discover the HP All-in-OneWireless setup troubleshooting To make sure your network connection is activeCannot connect to network during setup Connect to an integrated wireless Wlan 802.11 network onInvalid WEP key during wireless setup Invalid passphrase during wireless setupNetwork software installation troubleshooting Received a System Requirements Error No TCP/IP Fax setup troubleshooting Fax test failedSolution What to do Fax Hardware Test failedFax Connected to Active Telephone Wall Jack test failed Phone Cord Connected to Correct Port on Fax test failed Using Correct Type of Phone Cord with Fax test failed Dial Tone Detection test failed HP All-in-One is having problems sending and receiving faxes Fax Line Condition test failedTroubleshooting and support Try setting the Fax Speed to Medium 14400 or Slow If you hear noiseHP All-in-One is having problems sending a manual fax HP All-in-One cannot send faxes, but can receive faxesHP All-in-One cannot receive faxes, but can send faxes Troubleshooting and support Fax tones are recorded on my answering machine To clear a paper jam from the Two-sided printing accessory Clear paper jamsTo clear a paper jam in the automatic document feeder Information on ink cartridges and the print head If you have a problem, follow these steps Support processProduct specifications System requirementsEnergy Star notice Ink cartridge yield Regulatory notices Regulatory model identification numberWarranty Technical information

Related manuals

Manual 309 pages 10.38 Kb

Manual 16 pages 46.21 Kb