HP C7100 manual Wireless setup troubleshooting, To print the network configuration

Page 97

Troubleshooting and support

Chapter 5

Solution Try reinserting the cables. Or, if necessary, try a different cable.

Cause The HP All-in-One is assigned an AutoIP address instead of DHCP.

Solution This indicates that the HP All-in-One is not connected properly to the network. Check the following:

●Make sure all cables are connected properly and securely.

●If the cables are connected properly, your access point, router, or home gateway might not be sending an address. If this is the case, you might need to reset the device.

●Make sure the HP All-in-One is on the correct network.

Cause The HP All-in-One is on the wrong subnet or gateway.

Solution Print a network configuration page, and verify that the router and HP All-in-One are on the same subnet and gateway.

To print the network configuration page

1.On the control panel of the HP All-in-One, press Setup.

2.Press until Network is highlighted, and then press OK.

3.Press until View Network Settings is highlighted, and then press OK.

4.Press until Print Network Configuration Page is highlighted, and then press OK. This prints the network configuration page.

I am using a cable modem without a router and I do not have IP addresses

Cause If you have a computer with a cable modem, a separate Local Area Network (LAN) for your other computers, and no DHCP or router, you must use AutoIP to assign IP addresses to the other computers and to the HP All-in-One.

Solution

To obtain an IP address for the computer with the cable modem

➔Your Internet Service Provider (ISP) assigns either a static or dynamic IP address to the computer with the cable modem.

To assign IP addresses to the remaining computers and the HP All-in-One

➔Use AutoIP to assign IP addresses to the remaining computers and the HP All-in-One. Do not assign a static IP address.

Wireless setup troubleshooting

This section addresses problems you might encounter setting up a network. Check the device display for specific error messages.

●You do not see the SSID

●Weak signal

●Error message: Cannot connect to network

●Error message: Cannot connect to network. Unsupported authentication or encryption type

●Error message: Invalid WEP Key

●Error message: Invalid passphrase

●Error message: The access point timed out before a connection could be made

●Error message: More than 1 SecureEZ Setup access point found

●Error message: Another device connected to the access point before your device tried connecting

You do not see the SSID

Cause Your access point is not broadcasting its network name (SSID) because the Broadcast SSID option is turned off..

94

HP Photosmart C7100 All-in-One series

Page 96 Page 98
Image 97
Page 96 Page 98
Contents HP Photosmart C7100 All-in-One series Basics Guide Hewlett-Packard Company notices Contents Index Print from your computer Print photosCopy ScanLabel Description HP All-in-One at a glanceControl panel features Label Name and Description Use the HP Photosmart software Find more information Access the onscreen HelpHP Photosmart Mac Help appears If you want to Wired network setupSee this section Connect the HP All-in-One to the network What you need for a wired networkTo connect the HP All-in-One to the network Install the software for a network connectionTo install the Mac HP All-in-One software To install the Windows HP All-in-One softwareIntegrated wireless Wlan 802.11 network setup Connect to an integrated wireless Wlan 802.11 network What you need for an integrated wireless Wlan 802.11 networkIf you do not see your network name in the list To connect the HP All-in-One with the Wireless Setup WizardWhat you need for an ad hoc network Wireless ad hoc network setupPrepare a Windows XP computer To disable LAN connections with Windows XPTo prepare your computer On the Windows Control Panel, click Security CenterPrepare a Mac To create a new network profile Create a network profile for other operating systemsSelect Create Network… Click Show OptionsCommunication mode Ad Hoc Encryption enabled Connect to a wireless ad hoc networkTo connect to a wireless ad hoc network Connect to additional computers on a network Change basic network settings from the control panel Manage your network settingsTo run the Wireless Setup Wizard To restore network defaults Restore network defaultsTurn the wireless radio on and off To turn the wireless radio on and offAutomatic Full Half Access the Embedded Web Server IP Address Subnet Mask Default GatewayTo access the Embedded Web Server Use the Embedded Web ServerUse the Embedded Web Server setup wizard Network configuration page definitionsTo access the Embedded Web Server setup wizard General network settingsParameter Wired 802.3 network settingsDefault Gateway Wireless 802.11 network settings When you use the web or send an e-mail message, you use a Ssid Parameter Bluetooth settings Countries/regions with a parallel-type phone system Set up the HP All-in-One for faxingUSA Choose the correct fax setup for your home or officeSelect your fax setup case Recommended fax setup for parallel-type phone systems Other equipment/ services sharing your fax lineRecommended fax setup for serial-type phone systems Not applicable ServiceUp modem, and answering MachineTo set up the HP All-in-One with a separate fax line Case B Set up the HP All-in-One with DSLCase a Separate fax line no voice calls received Back view of the HP All-in-OneTo set up the HP All-in-One with DSL Fax setup To set up the HP All-in-One with a distinctive ring service Case D Fax with a distinctive ring service on the same lineCase E Shared voice/fax line To set up the HP All-in-One with a shared voice/fax lineCase F Shared voice/fax line with voice mail To set up the HP All-in-One with a computer dial-up modem To set up the HP All-in-One with voice mailCase H Shared voice/fax line with computer dial-up modem Fax Example of a parallel splitterAnswering machine Case I Shared voice/fax line with answering machineFax setup Example of a parallel splitter Fax setup Example of a parallel splitter Set the answer mode Change settings on the HP All-in-One to receive faxesSet the number of rings before answering To set the answer modeChange the answer ring pattern for distinctive ringing To test your fax setup from the control panel Test your fax setupSet the fax header To set a default fax header from the control panel Load originals Load originals and load paperLoad 10 x 15 cm 4 x 6 inch photo paper To load an original on the glassTo load 10 x 15 cm 4 x 6 inch photo paper in the photo tray Load an original in the Slide and Negative Film holderTo load 35 mm slides To load 35 mm negativesLower the lid of the HP All-in-One before starting the scan Make a copy Avoid paper jamsScan an image To make a copy from the control panelMake reprints of your photos Scan an original to a computerPress Scan Menu Press OK to select Select ComputerScan an original to a memory card or storage device Defaults optionPrint Options Print PreviewTo save a scan to a memory card or storage device Scan slides or negative filmTo scan a slide or negative To change the original typeTo print one or more 10 x 15 cm 4 x 6 inch photos Print 10 x 15 cm 4 x 6 inch photosTo edit the selected photo before printing To print more than one copy of the selected photoTo select additional photos for printing Press OK to select Select to PrintPrint Preview Print Now Print from a software applicationTo print from a software application Windows To print from a software application MacPress Fax Menu Send a basic faxPress Start Fax Black Press Start Fax Black againIf you do not have another page to fax Replace the ink cartridgesTo replace the ink cartridges Use the HP All-in-One features Align the printer Clean the glass Clean the HP All-in-OneClean the lid backing To clean the glassTo clean the lid backing Clean the exteriorTroubleshooting common setup issues Uninstall and reinstall the softwareTo uninstall from a Windows computer and then reinstall To uninstall from a Mac and then reinstall Hardware setup troubleshootingHP All-in-One will not turn on To set your language and country/region Display shows the wrong languageFax test failed Fax setup troubleshootingHP All-in-One does not print Fax Connected to Active Telephone Wall Jack test failed Fax Hardware Test failedWhat to do Phone Cord Connected to Correct Port on Fax test failed Using Correct Type of Phone Cord with Fax test failedDial Tone Detection test failed Fax Line Condition test failed HP All-in-One is having problems sending and receiving faxesTroubleshooting and support Troubleshooting and support Try setting the Fax Speed to Medium 14400 or Slow HP All-in-One cannot send faxes, but can receive faxes If you hear noise, do the followingHP All-in-One is having problems sending a manual fax HP All-in-One cannot receive faxes, but can send faxes Troubleshooting and support Troubleshooting and support Fax tones are recorded on my answering machine Telephone wall jack Wired network setup troubleshooting Network setup troubleshootingPrinter not Found screen appears during installation Received a System Requirements Error No TCP/IPTo establish an active network connection To make sure your network connection is activeTo print the network configuration Wireless setup troubleshootingYou do not see the Ssid Error message Cannot connect to network Weak signalCause An invalid WEP key was entered Error message Invalid WEP KeyError message Invalid passphrase Network software installation troubleshootingError message More than 1 SecureEZ Setup access point found To clear a paper jam from the rear door Clear paper jamsInformation on ink cartridges Calibration errorInk cartridge messages Cannot printInk cartridges are empty Ink cartridge problemInk cartridges are expired Ink expiration nearNon-HP ink Print head assembly is stalledOriginal HP ink depleted Print head failure To clear the print head assemblyPrinter alignment failed Replace ink cartridges soonWrong ink cartridges installed Support process Additional warranty optionsHP support by phone Phone support period Placing a callPrint specifications Paper specificationsSystem requirements Paper tray capacitiesScan specifications Copy specificationsFax specifications Physical specificationsInk cartridge warranty information Environmental specificationsRegulatory notices Regulatory model identification numberWarranty Index Negatives Basics Guide 111 112
Top Page Image Contents