To connect the HP All-in-One to the network
1.Remove the yellow plug from the back of the HP
2.Connect the Ethernet cable to the Ethernet port on the back of the HP
3.Connect the other end of the Ethernet cable to an available port on your Ethernet router or switch.
4.Once you have connected the HP
Install the software for a network connection
Use this section to install the HP
Note 1 If your computer is configured to connect to a series of network drives, make sure that your computer is currently connected to these drives before installing the software. Otherwise, HP
Note 2 Installation time can range from 20 to 45 minutes depending on your operating system, the amount of available space, and the processor speed of your computer.
Network setup
Basics Guide | 11 |