HP All-in-One overview
Chapter 1
To load 10 x 15 cm (4 x 6 inch) photo paper in the photo tray
1.Raise the output tray, and then pull out the photo tray.
2.Insert the stack of photo paper into the photo tray with the short edge forward and the print side down. Slide the stack of photo paper forward until it stops.
If the photo paper you are using has perforated tabs, load the photo paper so that the tabs are closest to you.
3.Slide the
Do not overload the photo tray; make sure the stack of photo paper fits within the photo tray and is no higher than the top of the
4.Push in the photo tray, and then lower the output tray.
Avoid paper jams
To help avoid paper jams, follow these guidelines.
●Remove printed papers from the output tray frequently.
●Prevent curled or wrinkled paper by storing all unused paper flat in a resealable bag.
●Ensure that paper loaded in the input tray lays flat and the edges are not bent or torn.
●If you are printing labels, ensure that the label sheets are no more than two years old. Labels on older sheets might peel off when the paper is pulled through the HP
●Do not combine different paper types and paper sizes in the input tray; the entire stack of paper in the input tray must be the same size and type.
●Adjust the
●Do not force paper too far forward in the input tray.
●Use paper types that are recommended for the HP
Make a copy
You can make quality copies from the control panel.
12 | HP Photosmart C5100 |