HP UX 11i v2 I/O Cards manual Software Installation

Page 19

Installing the Data Analyzer

Installing the Analyzer Software

NOTE

 

swremove will fail if any ACC daemon is still active. Terminate any

 

 

active ACC daemon indicated in the log file and try again.

 

 

Any or all of the ACC related products besides Data Analyzer can be

 

 

 

 

removed by selecting them and then marking them for removal. (Both

 

 

the terminal interface and the GUI interface for swremove behave the

 

 

same; only the means for selecting items differs.)

Step

4.

Select the items to be removed in the “Software Selection Window” and

 

 

mark for removal, using the “Mark for Remove” function under the

 

 

“Actions” menu.

 

 

When all items are marked, select the “Remove(analysis)” action.

 

 

Open “Logfile” to view running status of the removal process, and follow

 

 

any screen prompts until the removal process is done.

 

 

Software Installation

 

 

The ACC Data Analyzer software is read from the HP-UX Application

 

 

CD-ROM, in superuser mode, using the swinstall utility. The steps are

 

 

shown below.

Step

1.

Log in to the system as “root.”

Step

2.

Place the media in a local or remote CD-ROM drive.

Step

3.

Run swinstall, which behaves the same in the GUI interface as for the

 

 

terminal interface. When the “Specify Source” box opens, select “Source

 

 

Depot Type” to “Local CDROM,” or for a remote CD-ROM driver, select

 

 

for “Network Directory/CDROM” and set “Source Host Name...”. Select

 

 

“OK.”

Step

4.

Select the ACC Base Product (or the bundle that contains this). If the

 

 

ACC Base Product is already installed, you may just select the Analyzer

 

 

fileset from the ACC Base Product (hit the [Return] key to step into the

 

 

product). Open the “Actions” menu and select “Mark for Install.”

Step

5.

When this item has been marked, select “Install (analysis);” select “OK”

 

 

and proceed.

Chapter 2

19

Image 19
Contents Edition ACC X.25 Data Analyzer User’s GuidePage Legal Notices Page Publishing History Page Manual Organization PrefaceHardware Manuals Related DocumentationSoftware Manuals Contents Typical X.25 and Data Analyzer Sessions Overview Data Analyzer Overview Overview of ACC based Data Analyzer Data Analyzer Overview Data Analyzer Features Data Analyzer Requirements Installing the Data Analyzer Software Removal Installing the Analyzer SoftwareSoftware Installation Verifying Installation Following four events will be displayed Display exit Exit Program Dynamic Set-Up of Analyzer Configuration Configuring the AnalyzerFirst 8-Channel multiplexer card in the ACC subsystem by Data Analyzer Commands Detailed Command Descriptions Format DisplayDescription Both X.25 and Isdn analyzer sessions ExampleLCI Exit Examples HelpOptions ASCII8 Protocol Run Examples Runc ZLU.# ShowAzlu Shutdown Stop Stopd Network Configuration Mux Firmware Download File Setting Up the Network Configuration FileZLU Definitions Port DefinitionsRunning Ttgen and Starting the ACC Mux Starting ACC Subsystem and Analyzer Running Pdisplay ASCII8 10 X25CNT,0,X25CNTLDSIZE Sample Network Configuration File43EAH Sample Network Configuration File Appendix a Typical X.25 and Data Analyzer Introduction General Procedures