Data Analyzer Commands
stopd
| stopd |
| The stopd command stops the analyzer and deletes the analyzer ZLUs |
| in use provided that they were dynamically configured by previous use of |
| the runc command. |
| Format |
| stopd card port [subchannel] |
| Description |
| This command stops the protocol analyzer on the specified card, port and |
| (if an applicable card type is in use) subchannel. |
| pdisplay then deletes the corresponding pair of analyzer ZLUs. |
| This command cannot be used to delete analyzer ZLUs statically |
| configured in the network (ttgen) configuration file. |
|
|
NOTE | Be sure that you intend to DELETE the ZLU pair on the specified |
| mux/port/subchannel. If you only intend to halt the analyzer, use the |
| stop command. |
|
|
42 | Chapter 3 |