| Data Analyzer Commands |
| options |
z/Z | Turn off/ON Level 4 raw display (s/S option gives raw |
| mode). |
To change the option setting use the set parameter followed by one or more of the letters in the table above; for example, the command below turns off the event and timestamp display, enables the Level 4 raw data display, and turns on the Modem control lead change display.
Display> options set eZL
To show the current option setting, use just the options command by itself or use the show parameter. Note that the options display includes a summary of the letters required to modify the setting beside each of the state indications. For example, in the line “Level 2 header decode: Yes u/U,” the letters u/U are used to turn OFF or ON the Level 2 header decoding.
Display> options show
Current option settings
Level 2 Decode header: | Yes u/U | |
Display raw data: | No | v/V |
Level 3 Decode header: | Yes w/W | |
Decode facilities: | Yes x/X | |
Display raw data | No | y/Y |
Display Event# & time (e/E) No
Display Lead changes (l/L) | Yes |
Raw data display (see below) | ASCII8 |
Raw data single or full (s/S) | Single |
Reverse Sense DTE/DCE (r/R) DCE
Example
To set the display options back to their original state use the default parameter:
Display> options default
Default display options set
Chapter 3 | 33 |