HP UX 11i v2 I/O Cards manual Azlu

Page 39

 

Data Analyzer Commands

 

show

AZLU

This is the partner ZLU, which should also appear in

 

the display. The partner ZLU must be a different type

 

(DCE if this ZLU is a DTE, and DTE if DCE).

Mode

The mode field gives the action that pcapture takes

 

when the capture file is full. It may be Halt or Wrap. If

 

Halt is indicated then the analyzer will halt when the

 

file is full; if Wrap is indicated then the file will be

 

overwritten with new data.

Stat

This is the current state of the analyzer which may be

 

either run or stop.

LC.M

This shows that the LCN numbers are being used for

 

preprocessing filtering. Refer to the “run” command for

 

more details. If no LCN filters are set then this field

 

displays none and all traffic is captured to the file,

 

otherwise Yes is displayed and only the traffic for LCN

 

numbers specified in the run command are saved into

 

the file.

Size

This is the current maximum file size in bytes.

Name

This is the name of the capture file specified in the run

 

command or the default file name if no file was

 

specified. The default file name is of the form

 

/var/opt/acc/log/anz_ZLU.eve, where ZLU is the

 

ZLU number used in the run command.

Chapter 3

39

Image 39
Contents Edition ACC X.25 Data Analyzer User’s GuidePage Legal Notices Page Publishing History Page Manual Organization PrefaceRelated Documentation Hardware ManualsSoftware Manuals Contents Typical X.25 and Data Analyzer Sessions Overview Data Analyzer Overview Overview of ACC based Data Analyzer Data Analyzer Overview Data Analyzer Features Data Analyzer Requirements Installing the Data Analyzer Software Removal Installing the Analyzer SoftwareSoftware Installation Verifying Installation Following four events will be displayed Display exit Exit Program Dynamic Set-Up of Analyzer Configuration Configuring the AnalyzerFirst 8-Channel multiplexer card in the ACC subsystem by Data Analyzer Commands Detailed Command Descriptions Display FormatDescription Both X.25 and Isdn analyzer sessions ExampleLCI Exit Examples HelpOptions ASCII8 Protocol Run Examples Runc ZLU.# ShowAzlu Shutdown Stop Stopd Network Configuration Mux Firmware Download File Setting Up the Network Configuration FileZLU Definitions Port DefinitionsRunning Ttgen and Starting the ACC Mux Starting ACC Subsystem and Analyzer Running Pdisplay ASCII8 10 X25CNT,0,X25CNTLDSIZE Sample Network Configuration File43EAH Sample Network Configuration File Appendix a Typical X.25 and Data Analyzer Introduction General Procedures