HP UX 11i v2 I/O Cards manual Display, Format, Description

Data Analyzer Commands

display

display

The display command displays the contents of the capture file (.eve) to the screen or to standard out.

Format

display filename [-f] [-o opts] [-e e1 [e2]] [-l lcn#1 ...]

Description

The display command options have the following meanings:

-f	Follow the end of the file (i.e. wait and display data as
	it arrives).
-o	Set the display options (see the options command for
	details of option setting). Note the option settings
	modified in this command change the default options
	for the next display command.
-e	Specify event numbers to display. If <e1> is specified
	alone, then only <e1> will be displayed. If <e1> and
	<e2> are specified, then events in the range <e1> to
	<e2> are displayed.
-l	Display only the events for the LCN numbers specified.
	Up to 6 LCN numbers may be specified. Note the LCN
	masking done here is post processing from the file, and
	is different from the pre-processing done by the run
	command.
-p	Specify level 2 or level 3 protocol for analysis and trace
	display. See the protocol command for specific details
	on format for option -p.

Chapter 3 27