HP UX 11i v2 I/O Cards Setting Up the Network Configuration File, Mux Firmware Download File

Page 44

Network Configuration

Setting Up the Network Configuration File

NOTE

Setting Up the Network Configuration File

The first step is to configure the analyzer ports into the ttgen configuration file. A sample file is supplied with the product to illustrate how the configuration should be done. This file is called /opt/acc/cfg/x25an_sample.answ, or x25an_4ch_sample.answ. A full listing of these files is given at the end of this appendix. Some parts of these files are used below to illustrate the configuration process.

If the sample file is to be used as a test of the product, ensure that the multiplexer bus and slot numbers are changed in the file so that they correspond to the actual position of the multiplexer card.

Mux Firmware Download File

The Frame capture protocol used by the X.25 Protocol Analyzer is provided in all the downloadable files. The X.25 Protocol Analyzer may be used with any of these files.

The mux firmware download file is specified in the network configuration file in the card-type statement. For example:

z7340a 0 0:4 /opt/acc/z7340a/x25.zabs

Each multiplexer that is to run X.25 connections, or Data Analyzer ports, will need a card-type entry, such as z7340a. The bus and slot numbers must correspond to the physical position of the interface card. Refer to the ACC Installation and Configuration Guide for more information on determining the hardware location.

44

Appendix A

Image 44
Contents ACC X.25 Data Analyzer User’s Guide EditionPage Legal Notices Page Publishing History Page Preface Manual OrganizationSoftware Manuals Related DocumentationHardware Manuals Contents Typical X.25 and Data Analyzer Sessions Overview Data Analyzer Overview Overview of ACC based Data Analyzer Data Analyzer Overview Data Analyzer Features Data Analyzer Requirements Installing the Data Analyzer Installing the Analyzer Software Software RemovalSoftware Installation Verifying Installation Following four events will be displayed Display exit Exit Program Configuring the Analyzer Dynamic Set-Up of Analyzer ConfigurationFirst 8-Channel multiplexer card in the ACC subsystem by Data Analyzer Commands Detailed Command Descriptions Description DisplayFormat Example Both X.25 and Isdn analyzer sessionsLCI Exit Help ExamplesOptions ASCII8 Protocol Run Examples Runc Show ZLU.#Azlu Shutdown Stop Stopd Network Configuration Setting Up the Network Configuration File Mux Firmware Download FilePort Definitions ZLU DefinitionsRunning Ttgen and Starting the ACC Mux Starting ACC Subsystem and Analyzer Running Pdisplay ASCII8 Sample Network Configuration File 10 X25CNT,0,X25CNTLDSIZE43EAH Sample Network Configuration File Appendix a Typical X.25 and Data Analyzer General Procedures Introduction