HP UX 11i v2 I/O Cards manual Introduction, General Procedures

Page 54

Typical X.25 and Data Analyzer Sessions

Introduction

Introduction

This section provides the results of actual Data Analyzer sessions that were run using this software. The sessions were run on an 8-Channel multiplexer.

Because the 8-Channel multiplexer was not designed to provide ISDN service, only an X.25 session is described for this product.

General Procedures

The process involved with all sessions described in this appendix is generally as follows:

Ensure that the ACC multiplexer hardware and its base system and X.25 software are properly installed (per supplied manuals );

Ensure that the X.25/ACC configuration has been properly set up: refer to the X.25/ACC Installation and Configuration Guide as needed;

Start up the ZCOM muliplexer subsystem (described below);

Establish an X.25 connection via the ACC Multiplexer (described below);

Send packets over the connection using the X25Check utility (described below);

Run Data Analyzer’s pdisplay program to observe trace of the captured file.

These sessions were run with the HP-UX utility Script executing in the background, to preserve a trace of all terminal activity involved with the procedures.

54

Appendix B

Image 54
Contents ACC X.25 Data Analyzer User’s Guide EditionPage Legal Notices Page Publishing History Page Preface Manual OrganizationRelated Documentation Hardware ManualsSoftware Manuals Contents Typical X.25 and Data Analyzer Sessions Overview Data Analyzer Overview Overview of ACC based Data Analyzer Data Analyzer Overview Data Analyzer Features Data Analyzer Requirements Installing the Data Analyzer Installing the Analyzer Software Software RemovalSoftware Installation Verifying Installation Following four events will be displayed Display exit Exit Program Configuring the Analyzer Dynamic Set-Up of Analyzer ConfigurationFirst 8-Channel multiplexer card in the ACC subsystem by Data Analyzer Commands Detailed Command Descriptions Display FormatDescription Example Both X.25 and Isdn analyzer sessionsLCI Exit Help ExamplesOptions ASCII8 Protocol Run Examples Runc Show ZLU.#Azlu Shutdown Stop Stopd Network Configuration Setting Up the Network Configuration File Mux Firmware Download FilePort Definitions ZLU DefinitionsRunning Ttgen and Starting the ACC Mux Starting ACC Subsystem and Analyzer Running Pdisplay ASCII8 Sample Network Configuration File 10 X25CNT,0,X25CNTLDSIZE43EAH Sample Network Configuration File Appendix a Typical X.25 and Data Analyzer General Procedures Introduction