Network Configuration
Setting Up the Network Configuration File
Port Definitions
Each port on each multiplexer card to be used for the Data Analyzer must be correctly configured to support the Frame capture firmware protocol. Note the following configuration requirements:
•Select the correct mux and port for each analyzer connection.
•Set RS232 mode for both
•The baud rate is not important but set for an expected nominal rate (57600 chosen here).
•The Clocking option must be set to Ext.
•The Mode, clock multiplier, and encoding must be set to SDLC, x1, and NRZ. If NRZI encoding is used set this to NRZI instead.
Port 00:00 RS232 57600 Int SDLC x1 NRZ
Port 00:01 RS232 57600 Ext SDLC x1 NRZ
Port 00:02 RS232 57600 Ext SDLC x1 NRZ
Port 00:03 RS232 57600 Ext SDLC x1 NRZ
Port 00:04 RS232 57600 Ext SDLC x1 NRZ
Port 00:05 RS232 57600 Ext SDLC x1 NRZ
Port 00:06 RS232 57600 Ext SDLC x1 NRZ
Port 00:07 RS232 57600 Ext SDLC x1 NRZ
In the example file, mux 0 ports 0 and 1 are used for a sample X.25 connection that is looped back between these ports. marked External is connected as described below. Connect the
ZLU Definitions
Finally the ZLUs to be used for the Analyzer session must be defined. Take care to define these carefully since errors in these definitions may not be detected by ttgen. If there are such errors they may not be detected until the ports are used.
Term 0019 0:2 HDLC.FRAME | 0 | 0 | 90 20 1 0 0 | ”Protocol Analyzer” | |
Term 0020 0:3 HDLC.FRAME | 0 | 0 | 90 19 2 0 0 | ”Protocol Analyzer” | |
Term 0021 | 0:4 HDLC.FRAME | 0 | 0 | 90 22 1 0 0 | ”Protocol Analyzer” |
Term 0022 | 0:5 HDLC.FRAME | 0 | 0 | 90 21 2 0 0 | ”Protocol Analyzer” |
Term 0023 | 0:6 HDLC.FRAME | 0 | 0 | 90 24 1 0 0 | ”Protocol Analyzer” |
Term 0024 | 0:7 HDLC.FRAME | 0 | 0 | 90 23 2 0 0 | ”Protocol Analyzer” |
Appendix A | 45 |