HP UX 11i v2 I/O Cards manual Installing the Analyzer Software, Software Removal

Page 18

Installing the Data Analyzer

Installing the Analyzer Software

Installing the Analyzer Software

The data analyzer software is provided with the ACC Base Product, which comes in SD-UX format.

Installation requires the following general steps:

1. Remove any previous version of the data analyzer software with swremove.

2. Use swinstall to install the ACC base product (or just the data analyzer software if ACC base software is already installed).

3. Check /var/adm/sw/swagent.log for any errors during install.

4. Configure the analyzer.

 

 

Software Removal

 

 

If a previous version of the ACC X.25 Protocol Analyzer product is

 

 

already on the target system, remove it before the new software is

 

 

installed.

 

 

 

CAUTION

 

It is very important to follow the instructions, provided with the ACC

 

 

software that is currently installed in the system, to shut down and

 

 

remove that software. This procedure may change between major

 

 

releases of the ACC product.

 

 

 

Step

1.

Log in to the system as superuser.

Step

2.

Terminate the ACC Mux Subsystem by typing:

 

 

% zmasterd kill

Step

3.

Run swremove to remove the ACC X.25 Protocol Analyzer product.

 

 

% swremove

18

Chapter 2

Image 18
Contents ACC X.25 Data Analyzer User’s Guide EditionPage Legal Notices Page Publishing History Page Preface Manual OrganizationRelated Documentation Hardware ManualsSoftware Manuals Contents Typical X.25 and Data Analyzer Sessions Overview Data Analyzer Overview Overview of ACC based Data Analyzer Data Analyzer Overview Data Analyzer Features Data Analyzer Requirements Installing the Data Analyzer Installing the Analyzer Software Software RemovalSoftware Installation Verifying Installation Following four events will be displayed Display exit Exit Program Configuring the Analyzer Dynamic Set-Up of Analyzer ConfigurationFirst 8-Channel multiplexer card in the ACC subsystem by Data Analyzer Commands Detailed Command Descriptions Display FormatDescription Example Both X.25 and Isdn analyzer sessionsLCI Exit Help ExamplesOptions ASCII8 Protocol Run Examples Runc Show ZLU.#Azlu Shutdown Stop Stopd Network Configuration Setting Up the Network Configuration File Mux Firmware Download FilePort Definitions ZLU DefinitionsRunning Ttgen and Starting the ACC Mux Starting ACC Subsystem and Analyzer Running Pdisplay ASCII8 Sample Network Configuration File 10 X25CNT,0,X25CNTLDSIZE43EAH Sample Network Configuration File Appendix a Typical X.25 and Data Analyzer General Procedures Introduction