GE AEM25, AEQ25 Remote Control, Cool Mode, Energy Saver Mode, Fan Only Mode, Auto Fan Speed

Page 5

Do Not Operate in Freezing Outdoor Conditions

This cool-only air conditioner was not designed for freezing outdoor conditions. It must not be used in freezing outdoor conditions.

Remote Control

nTo ensure proper operation, aim the remote control at the signal receiver on the air conditioner.

nMake sure nothing is between the air conditioner and the remote control that could block the signal.

GEAppliances.com

nThe remote control signal has a range of up to 20 feet.

nMake sure batteries are fresh and installed correctly as indicated on the remote control.

nRemote contains a magnet allowing it to attach to metal surfaces.

Cool Mode

Use the Cool mode at Low, Med, High or Auto Fan Speed for cooling. Use the Temperature Increase

/Decrease pads to set the desired temperature between 64°F and 86°F in 1°F increments.

An electronic thermostat is used to maintain the room temperature. The compressor will cycle on

and off to keep the room at the set level of comfort. Set the thermostat at a lower number and the indoor air will become cooler. Set the thermostat at a higher number and the indoor air will become warmer.

NOTE: If the air conditioner is off and is then turned on while set to a Cool setting or if turned from a fan setting to a Cool setting, it may take approximately

3 minutes for the compressor to start and cooling to begin.

Energy Saver Mode

Controls the fan.

ON—The fan will cycle on and off with the

compressor. This results in wider variations of room temperature and humidity. Normally used when the

room is unoccupied. NOTE: The fan may continue to run for a short time after the compressor cycles off.

Cooling Descriptions

For Normal Cooling—Select the Cool mode and High or Med fan with a middle set temperature.

For Maximum Cooling—Select the Cool mode and High fan with a lower set temperature.

For Quieter and Nighttime Cooling—Select the Cool mode and Low fan with a middle set temperature.

OFF—The fan runs all the time, while the compressor cycles on and off.

Fan Only Mode

Use the Fan Only Mode at Low, Med or High fan

NOTE: Auto Fan Speed cannot be used when in the

speed to provide air circulation and filtering without

Fan Only Mode.

cooling. Since fan-only settings do not provide

 

cooling, a Set temperature cannot be entered. The

 

room temperature will appear in the display.

 

Auto Fan Speed

Set to Auto fan speed for the fan speed to automatically set to the speed needed to provide optimum comfort settings with the set temperature.

If the room needs more cooling, the fan speed

Power Outage Recovery Feature

will automatically increase. If the room needs less cooling, the fan speed will automatically decrease.

NOTE: Auto Fan Speed cannot be used when in the Fan Only Mode.

In the case of a power outage or interruption, the unit will automatically restart in the settings last used after the power is restored. If the Delay 1–24hr

feature was set, it will resume countdown. You may

 

need to set a new time if desired.

5

Image 5
Contents 49-7662 12-10 GE Do not use an adapter plug with this appliance Safety PrecautionsGEAppliances.com Risk of FIRE. Could cause serious injury or deathAbout the controls on the air conditioner Cool Mode Remote ControlEnergy Saver Mode Fan Only ModeCare and cleaning of the air conditioner Tools YOu WiLL Need BEfORE YOu BEgiNELECTRiCAL REQuiREMENTS Window Parts IncludedWindow Sash seal Right Accordion Panel Type E boltStorm WiNDOW REQuiREMENTS WiNDOW REQuiREMENTSPrepare the AiR CONDiTiONER Prepare the Case Prepare the AiR CONDiTiONER continuesCase Prepare the Case continuesCase continues Install the AIR Conditioner CaseInstall the AIR Conditioner Finish the Wall Opening Through-the-Wall Installation Instructions-OptionalProblem Possible Causes What To Do Troubleshooting TipsPage Page Original purchase Service to replace the defective part What Is Not CoveredGE Will Replace Warrantor General Electric Company. Louisville, KYOne Year Mabe Will ReplaceWarrantor Mabe Canada Inc Burlington, Ontario 22-24 Assistance à la clientèleAvertissement Conservez CES Instructions Commandes du Climatiseur Télécommande Propos des commandes du climatiseurMode Cool refroidissement TélécommandeMode Fan Only ventilateur uniquement Auto Fan Speed vitesse du ventilateur autoMise EN Garde NE faites PAS Entretien et nettoyage du climatiseurOutillage Nécessaires Avant DE CommencerExigences Électriques Ferrure de rebord Support en V Verrouillage de Pièces IncluesType a vis Type C vis Boulon de type EAppuyant sur les côtés du logement avec le bout Préparation DU ClimatiseurInstructions Relative À LA CONTRE- Fenêtre Préparation DU Climatiseur suite Préparation DU LogementPréparer LA Fenêtre ET Poser LE Capot Préparation DU Logement suitePréparer LA Fenêtre ET Poser LE Capot Suite Réglez les ferrures de rebord de fenêtreEmpêcher l’air et les insectes de pénétrer dans Pour preventez la verre brisez dans les fenêtresFinition DE L’OUVERTURE Dans LE MUR Important suiteCauses possibles Bruits normaux de fonctionnementProblème Que fairePage Page Pour la période d’ Nous remplacerons Climatiseur GE-Garantie Limitée D’un AnCe qui n’est pas couvert Garant Mabe Canada Inc Burlington, OntarioAssistance à la clientèle Site Internet GE Producto etiquetado *EnErgy Star Instrucciones de instalaciónNo use un enchufe adaptador con este electrodoméstico ¡ADVERTENCIAGEAppliances.com USO DE ProlongadoresControl remoto Acerca de los controles en el acondicionador de aireModo Cool Frío Energy Saver Mode Modo de ahorro de energíaModo de Fan Only Solo ventilador Velocidad de ventilador automáticaPrecaución no Opere el Cuidado y limpieza del acondicionador de aireREquISItoS ELéCtRICoS ANtES DE IniciarPARtES INCLuIDAS HERRAMIENtAS quE NECESItARáJunta del riel superior Soportes en V Soporte angular Trabas paraCuando se retire la parrilla del frente, el panel de REquISItoS Para LA VENtANAREquISItoS DE uNA VENtANA DE toRMENtAS Prepare EL ACoNDICIoNADoR DE Aire Prepare LA CarcasaPrepare LA Carcasa suite Prepare tHE WINDoW and INStALL tHE CasePrepare LA VENtANA E INStALE LA Caja De la carcasa con pernos tipoVentana para prevenir daño a INStALE EL ACoNDICIoNADoR EN LA CarcasaConecte el soporte de cierre De la ventana con uno tornilloTERMINE LA ABERtuRA IMPoRtANtEDE LA Pared Lea por completo y luego siga todos los pasosSonidos de operación normales Solucionar problemasProblema Causas posibles Qué hacer Notas Notas Notas Lo que no está cubierto Por el período de GE reemplazaráGarante General Electric Company. Louisville, KY Un añoPágina Web de GE Appliances Apoyo al consumidorReal Life Design Studio Consumer Support

AEM25, AEQ25 specifications

The GE AEQ25 and AEM25 are advanced aircraft engines that exemplify General Electric's commitment to innovation and efficiency in aviation technology. These engines are designed to power a range of medium-range aircraft, with a focus on providing superior performance, reliability, and sustainability.

One of the standout features of the AEQ25 and AEM25 engines is their state-of-the-art turbofan design. The engines incorporate advanced aerodynamics that enhance fuel efficiency while delivering powerful thrust. This turbofan architecture allows for a significant reduction in fuel consumption compared to older engine models, aligning with global efforts to lower carbon emissions in the aviation industry.

The AEQ25 and AEM25 engines utilize cutting-edge materials and manufacturing techniques. Timeless superalloys and composite materials are strategically employed to endure high temperatures and reduce weight. This combination not only enhances performance but also contributes to overall maintenance efficiency. The engines' design includes modular components, allowing for easy inspection and repairs, which minimizes downtime for aircraft operators and enhances the operational readiness of fleets.

A noteworthy technological advancement in these engine models is the introduction of digital monitoring and analytics capabilities. With integrated sensors, the AEQ25 and AEM25 engines provide real-time data on performance metrics, allowing for predictive maintenance. This technology helps operators anticipate potential issues before they become significant problems, ensuring that aircraft remain in optimal operating condition.

In terms of noise reduction, the AEQ25 and AEM25 engines are engineered to comply with stringent regulatory standards. Acoustic liners and optimized fan designs contribute to significantly lower noise levels during takeoff and landing, minimizing the impact on surrounding communities. This focus on noise abatement is increasingly essential as airports strive to balance growth with community concerns.

The AEQ25 and AEM25 engines are also designed with future sustainability in mind. They are compatible with sustainable aviation fuels (SAFs), further enhancing their environmental credentials. These bio-derived fuels can significantly reduce lifecycle greenhouse gas emissions, making these engines a preferred choice for environmentally conscious airlines.

Overall, the GE AEQ25 and AEM25 engines represent a blend of innovative technology, efficiency, and sustainability, poised to meet the demands of modern air travel while paving the way for a greener future in aviation. With their reliable performance, reduced operational costs, and commitment to environmental stewardship, these engines are set to play a crucial role in the evolving landscape of the aerospace industry.