Mounting the hood body
• Open the ducting panels.
• Disconnect the panel from the hood canopy by slid- ing the fixing pin lever.(A)
• Remove the metal grease filters by turning the han- dles provided.
• Adjust the two screws Vr, on brackets 11a, to a mini- mum.(B)
• Hook the hood canopy onto the two brackets 11a.
• From inside the hood canopy, adjust the screws Vr to set the Hood Canopy level.
• Tighten the safety screw 11.
( A )
Vr
( B )
Connections
DUCTED VERSION AIR EXHAUST SYSTEM
When installing the ducted version, connect the hood to the chimney using either a flexible or rigid
pipe ø 150 mm, the choice of which is left to the in- staller.
• Fix the pipe in position using sufficient pipe clamps (not supplied).
• Remove any activated charcoal filters.
RECIRCULATION VERSION AIR OUTLET | 8 | |
| ||
To install the Recirculation Version of the hood, the |
| |
optional Activated charcoal cartridge kit must be pur- | 16 | |
chased. | ||
|
•Screw the filter cover onto the air outlet, using four screws 12c (2.9 x 12.5).
•Fix the directional grille 8 on the recirculation air outlet using the 2 screws 12d (2,9 x 9,5) provided.
ø 150
12d
12c
EN |
| 1 |
| 19 |