Desa GK30, GK20 owner manual Operation, STORING, TRANSPORTING, or Shipping

Page 7

OPERATION STORING, TRANSPORTING, OR SHIPPING

5

OPERATION

WARNING: Review and understand the warnings in the Safety Information section, page 2. They are needed to safely operate this heater. Follow all local codes when using this heater.

TO START HEATER

1.Follow all ventilation and safety information.

2.Fill fuel tank with kerosene or No. 1 fuel oil.

3.Attach fuel cap.

4.Plug power cord of heater into standard 240 volt/50 hertz, grounded (earthed) outlet. Use an extension cord if needed. Use only a three-prong, grounded (earthed) extension cord.

EXTENSION CORD WIRE SIZE

REQUIREMENTS

Up to 30.5 meters (100 feet) long, use 1.0 mm2 (16 AWG) conductor

30.6to 61 meters (101 to 200 feet) long, use 1.5 mm2 (14 AWG) conductor

Push ON/OFF switch to ON () position and heater should start in 5 seconds. If ON/OFF switch light does not come on or heater does not start, see Troubleshooting (pages 6 and 7).

TO STOP HEATER

Push ON/OFF switch to OFF (O)position.

TO RESET HEATER

1.Push ON/OFF switch to OFF (O) position and wait 10 sec- onds (2 minutes if heater has been running).

2.Repeat steps under To Start Heater, above.

 

 

ON/OFF

ON/OFF Switch

Switch with

 

O

Light

O

with Light

 

 

STORING, TRANSPORTING, OR SHIPPING

Note: If shipping, transport companies require fuel tanks to be empty.

1.Drain fuel tank.

Note: Some models have drain plug on underside of fuel tank. If so, remove drain plug to drain all fuel. If heater does not have drain plug, drain fuel through fuel cap opening. Be sure all fuel is removed.

2.Replace drain plug if provided.

3.If any debris is noted in old fuel, add 1 or 2 quarts of clean kerosene to tank, stir, and drain again. This will prevent ex- cess debris from clogging filters during future use.

4.Replace fuel cap or drain plug. Properly dispose of old and dirty fuel. Check with local automotive service stations that recycle oil.

5.If storing, store heater in dry place. Make sure storage place is free of dust and corrosive fumes.

IMPORTANT: Do not store kerosene over summer months for use during next heating season. Using old fuel could damage heater.

Figure 5 - ON/OFF Switch,

Figure 6 - ON/OFF Switch,

Model GK20

Model GK30

108954

Image 7
Contents Appareils DE Chauffage Individuels À AIR Forcé 108954 Portable Forced AIR Heaters Table of ContentsSafety Information For Model GK30 only AssemblyProduct Identification UnpackingVentilation Fuels Theory of OperationSTORING, TRANSPORTING, or Shipping OperationTroubleshooting Preventative Maintenance ScheduleHow Often How To See Fuel Filter, See Nozzle Assembly,Diagram, See Wiring Diagram,Model GK20 Service ProceduresUpper Shell Removal Fuel FilterIgnitor Disconnecting Ignitor Wires from Ignition Control AssemblyAIR OUTPUT, AIR INTAKE, and Lint Filters Pump Pressure AdjustmentAirline Replacement and Proper Routing, Nozzle AssemblyProcedure if Rotor is Binding Fuel and AIR Line Replacement and Proper RoutingPump Rotor FAN Ignition Control AssemblyRemove Old Assembly Reinstall insert and rotor Perform steps 10 through 12,Installing the New Assembly Service Procedures Wiring DiagramAccessories SpecificationsIllustrated Parts Breakdown Motor and Pump AssemblyModel GK20 Number Description QTY Parts ListModel GK30 KEY Part Number Description QTY KEY Part Number Description QTY Wheels and HandlesBIEMMEDUE, S.p.A Via Industria Cherasco CN EC Conformity DeclarationItalia Riscaldatori Mobili AD Aria Forzata Avvertenze Informazioni Sulla SicurezzaFunzione il riscaldatore PER I Soli Modello GK30 Identificazione DEI ProdottiDisimballaggio AssemblaggioVentilazione Combustibili Principi DI FunzionamentoSpegnimento DEL Riscaldatore FunzionamentoCONSERVAZIONE, Trasporto O Spedizione Accensione DEL RiscaldatoreArticolo Frequenza Programma DI Manutenzione PreventivaVedere Ventola a pagina Avvertenza alta tensione Individuazione DEI GuastiVedere Filtri di ingresso e di uscita Avvia Elettrico sia resettatoDiagrammi Controllo dell’accensione lo spegne dopo unModello GK20 Procedure DI ManutenzioneRimozione DEL Semiguscio Superiore Filtro DEL CombustibileFigura 12. Sostituzione dell’accenditore AccenditoreImportante non oliare i filtri Regolazione Della Pressione DEL CompressorePressione del Modello compressore bar/psi Dell’aria a pagina UgelloRotore DEL Compressore Sostituzione E Posa DEI Tubi DEL Combustibile E DELL’ARIAFigura 25. Carteggiatura del rotore VentolaGruppo DI Controllo DELL’ACCENSIONE Installazione del gruppo nuovoRimozione del gruppo vecchio Modello GK20 Veduta Esplosa DEI ComponentiGruppo del motore e del compressore Numero DI Descrizione Catalogo DEL Pezzo Distinta DEI ComponentiModello GK30 Controdado esagonale 105880-01 Fusibile Numero DI Descrizione Catalogo DEL Pezzo Ruote ED ImpugnatureDati Tecnici Diagrammi Schematici DEI Collegamenti ElettriciPortata nominale KW Combustibile Disponibili presso il concessionario locale AccessoriManometro HA1180 KIT Delle Ruote E DELL’IMPUGNATURA Standard HA1206Dichiarazione DI Conformità CE Italia Table DES Marières Appareils DE Chauffage Individuels À AIR ForcéAvertissements Pour Modè LE GK30 Nomenclature DES PiècesDéballage MontagePrincipes DE Fonctionnement CarburantsPour Arrê TER L’APPAREIL DE Chauffage ENTREPOSAGE, Transport OU ExpéditionMise EN Marche DE L’APPAREIL Conditions Requises Pour LES Rallonges É LectriquesAvertissement Haute tension Tableau D’ENTRETIEN PréventifDépannage Lé ment Pé riodicité Opé rationSchéma électrique , Voir Réglage de la pression de laVoir Filtre à carburant , Entreposage, transport ou expéditionModè le GK20 Procédures D’ENTRETIENDÉ Pose DU Couvercle Filtre À CarburantAllumeur Dé branchement des fils d’allumeur de la commande d’allumageRÉ Glage DE LA Pression DE LA Pompe Filtres DE Sortie D’AIR, D’ENTRÉ E D’AIR ET À PelucheDé pose de lensemble gicleur-adaptateur GicleurProcé dure en cas de grippage Rotor DE LA PompeVentilateur Emplacement des vis de ré glage de l’é cartLectroniques Commande D’ALLUMAGEInstallation des piè ces neuves Dé pose des piè ces existantesSpécifications AccessoiresSchémas Électriques GK20 VUE ÉclatéeRÉ F DE PIÈ CE DÉ Signation Liste DES PiècesEnsemble moteur et pompe GK30˚ DE Numé RO RÉ F DE PIÈ CE DÉ Signation QTÉ Modè LE GK30 Roues ET GuidonsDéclaration DE Conformité À LA CE Italia Inhaltsverzeichnis Tragbare Hochdruck HeissluftturbinenVorschriften zu erfolgen SicherheitsinformationenWarnhinweise Gefahr Eine Kohlenmonoxydvergiftung kann tödlich seinNUR FÜ R GK30 Modell ProduktbeschreibungZusammenbau AuspackenEntlüftung KraftstoffearbeitsweiseLAGERUNG, TRANSPORT, Versand BedienungSiehe Lagerung, Transport oder Versand Regelmässige WartungFehlersuche Teil Hä ufigkeit Durchfü hrungRung, Transport, Versand auf Seite Siehe Pumpendruckeinstellung aufGK30 Modell WartungsverfahrenEntfernen DES Oberen Gehä Uses KraftstoffilterZÜ Nder LUFTAUSLASS-,LUFTEINLASS-UNDSTAUB- Filter PumpendruckeinstellungDÜ Senbaugruppe Pumpenrotor Entfernen DER KRAFTSTOFF- UND Luftschlä Uche UND VerlegungVerfahren, wenn die Pumpe festgefressen ist Die Lüfterabdeckung und das obere Gehäuse wieder anbringen LÜ FterAlte Baugruppe entfernen ZÜ NdstromanlageNeue Baugruppe montieren Zusatzgeräte sind bei Ihrem zuständigen Händler erhältlich Technische DatenSchaltplan ZusatzgeräteMotor- und Pumpenbaugruppe Bebilderte ErsatzteillisteTeilnummer Beschreibung STÜ CK ErsatzteilkatalogGK30 Modell Kenn Teilnummer Beschreibung STÜ CK GK30 Modell Räder UND HandgriffeTragbare Hochdruck-Heizluftturbinen Modellnummern GK20, GK30 EU-ÜBEREINSTIMMUNGSERKLÄRUNGItalia 108954 Not a UPCRev. a